On zo, 2007-06-24 at 07:41 -0400, Tony Traugott wrote: > I have the exact same card as you. I didn't run into any problems. I've > attached my ivtv info here for you to review. I'm not so sure this is an > ivtv issue as it is Myth. If you want, you may email me directly at > [EMAIL PROTECTED] to discuss further without creating issues in > this post.
You do not need the patch mentioned below as your firmware is loading. The bug was fixed in later 2.6.20 kernels (I thought 2.6.20.2). Does your kernel log have any error messages when you try to use the card? Try to use the command line for test and not mythtv, does the below work? ivtv-tune -c <channel> or ivtv-tune -f <freq> cat /dev/videoX > test.mpg Greets Sander > 48.190420] Linux video capture interface: v2.00 > 48.364301] ivtv: ============= START INIT IVTV =================== > 48.364306] ivtv: version 0.10.1 (tagged release) loading > 48.364308] ivtv: Linux version: 2.6.20-16-generic SMP mod_unload > 48.364311] ivtv: In case of problems please include the debug info > between > 48.364313] ivtv: the START INIT IVTV and END INIT IVTV lines, along > with > 48.364315] ivtv: any module options, when mailing the ivtv-users > mailinglist. > 48.364443] ivtv0: Autodetected Hauppauge card (cx23416 based) > 48.364493] ACPI: PCI Interrupt 0000:00:06.0[A] -> GSI 17 (level, low) -> > IRQ 17 > 48.406350] nvidia: module license 'NVIDIA' taints kernel. > 49.209020] usbcore: registered new interface driver hiddev > 49.246693] input: USB KVM Switch 4 PORT V1.5 USB KVM Switch 4 PORT V1.5 > as /class/input/input1 > 49.246745] input: USB HID v1.10 Keyboard [USB KVM Switch 4 PORT V1.5 USB > KVM Switch 4 PORT V1.5] on usb-0000:00:10.1-2.1 > 49.270862] input: USB KVM Switch 4 PORT V1.5 USB KVM Switch 4 PORT V1.5 > as /class/input/input2 > 49.270973] input: USB HID v1.10 Mouse [USB KVM Switch 4 PORT V1.5 USB > KVM Switch 4 PORT V1.5] on usb-0000:00:10.1-2.1 > 49.270989] usbcore: registered new interface driver usbhid > 49.270992] drivers/usb/input/hid-core.c: v2.6:USB HID core driver > 49.310525] usbcore: registered new interface driver libusual > 49.326660] Initializing USB Mass Storage driver... > 49.430030] scsi0 : SCSI emulation for USB Mass Storage devices > 49.430156] usbcore: registered new interface driver usb-storage > 49.430159] USB Mass Storage support registered. > 49.430164] usb-storage: device found at 3 > 49.430165] usb-storage: waiting for device to settle before scanning > 49.621047] ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) > 49.838895] ivtv0: Encoder revision: 0x02050032 > 49.838898] ivtv0: Recommended firmware version is 0x02060039. > 49.899363] tveeprom 1-0050: Hauppauge model 26582, rev C699, serial# > 8799925 > 49.899369] tveeprom 1-0050: tuner model is TCL 2002N 5H (idx 99, type > 50) > 49.899373] tveeprom 1-0050: TV standards NTSC(M) (eeprom 0x08) > 49.899376] tveeprom 1-0050: audio processor is CX25843 (idx 37) > 49.899379] tveeprom 1-0050: decoder processor is CX25843 (idx 30) > 49.899382] tveeprom 1-0050: has no radio, has no IR receiver, has no IR > transmitter > 49.899385] ivtv0: Autodetected Hauppauge WinTV PVR-150 > 49.930901] tuner 1-0061: chip found @ 0xc2 (ivtv i2c driver #0) > 49.968028] cx25840 1-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #0) > 54.440192] usb-storage: device scan complete > 54.493678] scsi 0:0:0:0: Direct-Access Seagate FreeAgentDesktop > 100D PQ: 0 ANSI: 4 > 54.794906] cx25840 1-0044: loaded v4l-cx25840.fw firmware (16382 bytes) > 54.903645] SCSI device sda: 625142448 512-byte hdwr sectors (320073 MB) > 54.905095] sda: Write Protect is off > 54.905097] sda: Mode Sense: 1c 00 00 00 > 54.905100] sda: assuming drive cache: write through > 54.907208] SCSI device sda: 625142448 512-byte hdwr sectors (320073 MB) > 54.908580] sda: Write Protect is off > 54.908582] sda: Mode Sense: 1c 00 00 00 > 54.908583] sda: assuming drive cache: write through > 54.908588] sda: sda1 > 54.917610] sd 0:0:0:0: Attached scsi disk sda > 54.921349] wm8775 1-001b: chip found @ 0x36 (ivtv i2c driver #0) > 54.987258] ivtv0: Registered device video0 for encoder MPEG (4 MB) > 54.987621] ivtv0: Registered device video32 for encoder YUV (2 MB) > 54.988002] ivtv0: Registered device vbi0 for encoder VBI (1 MB) > 54.988236] ivtv0: Registered device video24 for encoder PCM audio (1 MB) > 54.988491] tuner 1-0061: type set to 50 (TCL 2002N) > 55.114004] sd 0:0:0:0: Attached scsi generic sg0 type 0 > 55.376991] ivtv0: Initialized Hauppauge WinTV PVR-150, card #0 > 55.377019] ivtv: =============== END INIT IVTV ================= _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
