Hello everyone. I've built a little htpc using archlinux with latest kernel 2.6.22.5. Both the Hauppauge PVR-150 and an old Hauppauge PCI-Fm video cards are detected by the kernel.
Aug 26 18:37:19 Mozart ivtv: ==================== START INIT IVTV ==================== Aug 26 18:37:19 Mozart ivtv: version 1.0.0 (2.6.22-ARCH SMP preempt mod_unload 686 ) loading Aug 26 18:37:19 Mozart ivtv0: Autodetected Hauppauge card (cx23416 based) Aug 26 18:37:19 Mozart ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 18 Aug 26 18:37:19 Mozart ACPI: PCI Interrupt 0000:01:0a.0[A] -> Link [LNKC] -> GSI 18 (level, low) -> IRQ 21 Aug 26 18:37:19 Mozart ivtv0: Unreasonably low latency timer, setting to 64 (was 32) Aug 26 18:37:19 Mozart lp0: using parport0 (interrupt-driven). Aug 26 18:37:19 Mozart bttv: driver version 0.9.17 loaded Aug 26 18:37:19 Mozart bttv: using 8 buffers with 2080k (520 pages) each for capture Aug 26 18:37:19 Mozart PPP generic driver version 2.4.2 Aug 26 18:37:19 Mozart input: PC Speaker as /class/input/input5 Aug 26 18:37:19 Mozart ppdev: user-space parallel port driver Aug 26 18:37:19 Mozart ivtv0: loaded v4l-cx2341x-enc.fw firmware (376836 bytes) Aug 26 18:37:19 Mozart ivtv0: Encoder revision: 0x02060039 Aug 26 18:37:19 Mozart tveeprom 2-0050: Hauppauge model 26034, rev C197, serial# 2977397 Aug 26 18:37:19 Mozart tveeprom 2-0050: tuner model is TCL 2002MB_3H (idx 97, type 55) Aug 26 18:37:19 Mozart tveeprom 2-0050: TV standards PAL(B/G) PAL(D/D1/K) (eeprom 0x44) Aug 26 18:37:19 Mozart tveeprom 2-0050: audio processor is CX25842 (idx 36) Aug 26 18:37:19 Mozart tveeprom 2-0050: decoder processor is CX25842 (idx 29) Aug 26 18:37:19 Mozart tveeprom 2-0050: has no radio, has IR receiver, has IR transmitter Aug 26 18:37:19 Mozart ivtv0: Autodetected Hauppauge WinTV PVR-150 Aug 26 18:37:19 Mozart ivtv0: reopen i2c bus for IR-blaster support Aug 26 18:37:19 Mozart tuner 2-0061: chip found @ 0xc2 (ivtv i2c driver #0) Aug 26 18:37:19 Mozart cx25840 2-0044: cx25842-23 found @ 0x88 (ivtv i2c driver #0) Aug 26 18:37:19 Mozart cx25840 2-0044: loaded v4l-cx25840.fw firmware (16382 bytes) Aug 26 18:37:19 Mozart wm8775 2-001b: chip found @ 0x36 (ivtv i2c driver #0) Aug 26 18:37:19 Mozart tuner 2-0061: type set to 55 (TCL 2002MB) Aug 26 18:37:19 Mozart ivtv0: Registered device video0 for encoder MPEG (4 MB) Aug 26 18:37:19 Mozart ivtv0: Registered device video32 for encoder YUV (2 MB) Aug 26 18:37:19 Mozart ivtv0: Registered device vbi0 for encoder VBI (1 MB) Aug 26 18:37:19 Mozart ivtv0: Registered device video24 for encoder PCM audio (1 MB) Aug 26 18:37:19 Mozart ivtv0: Initialized Hauppauge WinTV PVR-150, card #0 Aug 26 18:37:19 Mozart ivtv: ==================== END INIT IVTV ==================== When I watch Tv using the PVR-150 I am experiencing pretty heavy flickering (jittering). The image quality (and sound btw too) is so bad that I can't watch Tv using the PVR-150. I know that the card itself is working well (tried in using WinXp) and I know the channel frequencies are ok because I am not experiencing any of these problems using the other video card on mythtv. I'm quite clueless on how to solve this problem. Any help is much appreciated. If you need further information regarding my setup or any other output, I'll provide it. Bernahrd _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
