On 10/26/07, Brian J. Stults <[EMAIL PROTECTED]> wrote: > I have had a PVR-150 for a couple years and I just added a PVR-500 to > the same system. The PVR-150 will not initialize when the PVR-500 is > also installed. If I take the 500 out, the 150 works fine again. The > 300 works regardless of whether the 150 is installed or not. I am using > the latest firmware from ivtvdriver.org as of today. I've tried putting > the two cards in all different combinations of PCI slots. The relevant > output is below. Any suggestions? Thanks. > > kernel: 2.6.23 (but same with .21 and .22) > driver: 1.0.3 (but same with 1.0.2) > > ivtv: Start initialization, version 1.0.0 > ivtv0: Initializing card #0 > ivtv0: Autodetected Hauppauge card (cx23416 based) > ivtv0: Unreasonably low latency timer, setting to 64 (was 32) > ivtv0: Loaded v4l-cx2341x-enc.fw firmware (376836 bytes) > ivtv0: Encoder revision: 0x02060039 > tveeprom 2-0050: Huh, no eeprom present (err=-121)? > tveeprom 2-0050: Encountered bad packet header [a8]. Corrupt or not a > Hauppauge eeprom. > ivtv0: Invalid EEPROM > ivtv0: i2c hardware 0x00000001 (cx2584x) not found for command 0xc008561c > ivtv0: i2c addr 0x44 not found for command 0x4008646f > ivtv0: i2c hardware 0x00000020 (wm8775) not found for command 0x4008646d > ivtv0: i2c hardware 0x00000001 (cx2584x) not found for command 0x4008646d > ivtv0: i2c hardware 0x00000001 (cx2584x) not found for command 0xc008561c > ivtv0: i2c hardware 0x00000001 (cx2584x) not found for command 0xc008561c > ivtv0: i2c hardware 0x00000001 (cx2584x) not found for command 0xc008561c > ivtv0: Registered device video0 for encoder MPEG (4 MB) > ivtv0: Registered device video32 for encoder YUV (2 MB) > ivtv0: Registered device vbi0 for encoder VBI (1 MB) > ivtv0: Registered device video24 for encoder PCM audio (1 MB) > ivtv0: Registered device radio0 for encoder radio > ivtv0: Initialized card #0: Hauppauge WinTV PVR-150 > ivtv1: Initializing card #1 > ivtv1: Autodetected Hauppauge card (cx23416 based) > ivtv1: Unreasonably low latency timer, setting to 64 (was 32) > ivtv1: Loaded v4l-cx2341x-enc.fw firmware (376836 bytes) > ivtv1: Encoder revision: 0x02060039 > tuner 3-0043: chip found @ 0x86 (ivtv i2c driver #1) > tda9887 3-0043: tda988[5/6/7] found @ 0x43 (tuner) > tuner 3-0060: TEA5767 detected. > tuner 3-0060: chip found @ 0xc0 (ivtv i2c driver #1) > tuner 3-0060: type set to 62 (Philips TEA5767HN FM Radio) > tuner 3-0061: chip found @ 0xc2 (ivtv i2c driver #1) > cx25840 3-0044: cx25843-24 found @ 0x88 (ivtv i2c driver #1) > cx25840 3-0044: loaded v4l-cx25840.fw firmware (16382 bytes) > wm8775 3-001b: chip found @ 0x36 (ivtv i2c driver #1) > tveeprom 3-0050: Hauppauge model 23552, rev E692, serial# 10235710 > tveeprom 3-0050: tuner model is Philips FQ1236A MK4 (idx 92, type 57) > tveeprom 3-0050: TV standards NTSC(M) (eeprom 0x08) > tveeprom 3-0050: second tuner model is Philips TEA5768HL FM Radio (idx > 101, type 62) > tveeprom 3-0050: audio processor is CX25843 (idx 37) > tveeprom 3-0050: decoder processor is CX25843 (idx 30) > tveeprom 3-0050: has radio, has no IR receiver, has no IR transmitter > ivtv1: Autodetected WinTV PVR 500 (unit #1) > tuner 3-0061: type set to 57 (Philips FQ1236A MK4) > ivtv1: Registered device video1 for encoder MPEG (4 MB) > ivtv1: Registered device video33 for encoder YUV (2 MB) > ivtv1: Registered device vbi1 for encoder VBI (1 MB) > ivtv1: Registered device video25 for encoder PCM audio (1 MB) > ivtv1: Registered device radio1 for encoder radio > ivtv1: Initialized card #1: WinTV PVR 500 (unit #1) > ivtv2: Initializing card #2 > ivtv2: Autodetected Hauppauge card (cx23416 based) > ivtv2: Unreasonably low latency timer, setting to 64 (was 32) > ivtv2: Loaded v4l-cx2341x-enc.fw firmware (376836 bytes) > ivtv2: Encoder revision: 0x02060039 > tuner 4-0043: chip found @ 0x86 (ivtv i2c driver #2) > tda9887 4-0043: tda988[5/6/7] found @ 0x43 (tuner) > tuner 4-0061: chip found @ 0xc2 (ivtv i2c driver #2) > cx25840 4-0044: cx25843-24 found @ 0x88 (ivtv i2c driver #2) > cx25840 4-0044: loaded v4l-cx25840.fw firmware (16382 bytes) > wm8775 4-001b: chip found @ 0x36 (ivtv i2c driver #2) > tveeprom 4-0050: Hauppauge model 23552, rev E692, serial# 10235710 > tveeprom 4-0050: tuner model is Philips FQ1236A MK4 (idx 92, type 57) > tveeprom 4-0050: TV standards NTSC(M) (eeprom 0x08) > tveeprom 4-0050: second tuner model is Philips TEA5768HL FM Radio (idx > 101, type 62) > tveeprom 4-0050: audio processor is CX25843 (idx 37) > tveeprom 4-0050: decoder processor is CX25843 (idx 30) > tveeprom 4-0050: has radio, has no IR receiver, has no IR transmitter > ivtv2: Correcting tveeprom data: no radio present on second unit > ivtv2: Autodetected WinTV PVR 500 (unit #2) > tuner 4-0061: type set to 57 (Philips FQ1236A MK4) > ivtv2: Registered device video2 for encoder MPEG (4 MB) > ivtv2: Registered device video34 for encoder YUV (2 MB) > ivtv2: Registered device vbi2 for encoder VBI (1 MB) > ivtv2: Registered device video26 for encoder PCM audio (1 MB) > ivtv2: Initialized card #2: WinTV PVR 500 (unit #2) > ivtv: End initialization > > > Module Size Used by > lirc_serial 14452 1 > lirc_dev 14308 1 lirc_serial > nvidia 6215440 40 > agpgart 33328 1 nvidia > nfsd 95912 13 > exportfs 5376 1 nfsd > nfs 126828 1 > lockd 65672 3 nfsd,nfs > sunrpc 166684 9 nfsd,nfs,lockd > psmouse 38928 0 > ide_generic 1408 0 [permanent] > wm8775 6156 0 > cx25840 25872 0 > tuner 63400 0 > usblp 13312 0 > snd_intel8x0 31004 1 > snd_ac97_codec 94508 1 snd_intel8x0 > ac97_bus 2304 1 snd_ac97_codec > snd_pcm_oss 42784 1 > snd_mixer_oss 16512 1 snd_pcm_oss > snd_pcm 73864 3 snd_intel8x0,snd_ac97_codec,snd_pcm_oss > snd_timer 21892 1 snd_pcm > snd 50788 6 > snd_intel8x0,snd_ac97_codec,snd_pcm_oss,snd_mixer_oss,snd_pcm,snd_timer > ivtv 133648 2 > evdev 10496 0 > firmware_class 9600 2 cx25840,ivtv > cx2341x 12548 1 ivtv > ide_cd 39072 0 > tveeprom 15888 1 ivtv > videodev 28288 3 ivtv > v4l2_common 17536 6 wm8775,cx25840,tuner,ivtv,cx2341x,videodev > v4l1_compat 14852 2 ivtv,videodev > ohci_hcd 18948 0 > usbcore 125848 3 usblp,ohci_hcd > cdrom 36256 1 ide_cd > i2c_nforce2 6528 0 > soundcore 7648 2 snd > snd_page_alloc 10504 2 snd_intel8x0,snd_pcm > > _______________________________________________ > ivtv-users mailing list > [email protected] > http://ivtvdriver.org/mailman/listinfo/ivtv-users >
Have you tried shutdown and power off, then restart? I have a PVR-350 and PVR-150 and at one time I saw different behavior on a simple reboot vs. a shutdown/restart. _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
