On Tuesday 13 November 2007 22:20:33 Sander Sweers wrote:
> On di, 2007-11-13 at 18:28 +0100, Hans Verkuil wrote:
> > So please help me out by downloading my ivtv-i2c tree here:
> > http://linuxtv.org/hg/~hverkuil/ivtv-i2c/archive/tip.tar.bz2
>
> I pulled from you branch instead of downloading.
>
> > Whether it works or not, please post (or mail) the ivtv
> > initialization messages from the kernel log so that I know which
> > devices are tested.
>
> All seems to work fine so far but if anything comes up during
> recording I'll let you know.
Well, it either works or not, so this isn't a duration test luckily.
But can you give me the kernel version you are using?
Thanks,
Hans
>
> Greets
> Sander
>
> Linux video capture interface: v2.00
> ivtv: Start initialization, version 1.1.0
> ivtv0: Initializing card #0
> ivtv0: Autodetected Hauppauge card (cx23416 based)
> ACPI: PCI Interrupt 0000:04:05.0[A] -> GSI 20 (level, low) -> IRQ 20
> tveeprom 1-0050: The eeprom says no radio is present, but the tuner
> type tveeprom 1-0050: indicates otherwise. I will assume that radio
> is present.
> tveeprom 1-0050: Hauppauge model 26039, rev F0A5, serial# 8837856
> tveeprom 1-0050: tuner model is TCL MPE05-2 (idx 105, type 38)
> tveeprom 1-0050: TV standards PAL(B/G) PAL(I) SECAM(L/L') PAL(D/D1/K)
> (eeprom 0x74)
> tveeprom 1-0050: audio processor is CX25842 (idx 36)
> tveeprom 1-0050: decoder processor is CX25842 (idx 29)
> tveeprom 1-0050: has radio, has IR receiver, has IR transmitter
> ivtv0: Autodetected Hauppauge WinTV PVR-150
> ivtv0: Reopen i2c bus for IR-blaster support
> saa7146: register extension 'budget_ci dvb'.
> cx25840 1-0044: cx25842-23 found @ 0x88 (ivtv i2c driver #0)
> tuner 1-0043: chip found @ 0x86 (ivtv i2c driver #0)
> tda9887 1-0043: tda988[5/6/7] found @ 0x43 (tuner)
> tuner 1-0061: chip found @ 0xc2 (ivtv i2c driver #0)
> wm8775 1-001b: chip found @ 0x36 (ivtv i2c driver #0)
> tuner-simple 1-0061: type set to 38 (Philips PAL/SECAM multi
> (FM1216ME MK3))
> ivtv0: Registered device video0 for encoder MPG (4096 kB)
> ivtv0: Registered device video32 for encoder YUV (2048 kB)
> ivtv0: Registered device vbi0 for encoder VBI (1024 kB)
> ivtv0: Registered device video24 for encoder PCM (320 kB)
> ivtv0: Registered device radio0 for encoder radio
> ivtv0: Initialized card #0: Hauppauge WinTV PVR-150
> ivtv: End initialization
> ACPI: PCI Interrupt 0000:04:06.0[A] -> GSI 21 (level, low) -> IRQ 21
> saa7146: found saa7146 @ mem ffffc20000032c00 (revision 1, irq 21)
> (0x13c2,0x1010).
> saa7146 (0): dma buffer size 192512
> DVB: registering new adapter (TT-Budget-C-CI PCI)
> adapter has MAC addr = 00:d0:5c:67:c3:3c
> input: Budget-CI dvb ir receiver saa7146 (0)
> as /devices/pci0000:00/0000:00:06.0/0000:04:06.0/input/input3
> budget_ci: CI interface initialised
> DVB: registering frontend 0 (ST STV0297 DVB-C)...
> lirc_dev: IR Remote Control driver registered, major 61
> lirc_i2c: chip 0x10020 found @ 0x71 (Hauppauge PVR150)
> lirc_dev: lirc_register_plugin: sample_rate: 10
> ivtv0: Loaded v4l-cx2341x-enc.fw firmware (376836 bytes)
> ivtv0: Encoder revision: 0x02060039
> cx25840 1-0044: loaded v4l-cx25840.fw firmware (16382 bytes)
>
>
>
> _______________________________________________
> ivtv-devel mailing list
> [EMAIL PROTECTED]
> http://ivtvdriver.org/mailman/listinfo/ivtv-devel
_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users
