Hi, I'm running gentoo with kernel 2.6.25-gentoo-r4 and cannot sem to get the PVR-250 card to work with mythtv. The tuner, saa7115 and msp3400 kernel modules are not loading for some reason. I've tried googling the error but haven't found anything similar. I was wondering if anyone has come across a similar issue or if there are additional diagnostics I can run to help narrow down the failure? I've attached a copy of my dmesg output.
Thanks, Paul ivtv: Start initialization, version 1.2.0 ivtv0: Initializing card #0 ivtv0: Autodetected Hauppauge card (cx23415 based) ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 19 ACPI: PCI Interrupt 0000:01:06.0[A] -> Link [LNKB] -> GSI 19 (level, low) -> IRQ 19 tveeprom 0-0050: Hauppauge model 48432, rev I110, serial# 6145626 tveeprom 0-0050: tuner model is Philips FI1236 MK2 (idx 10, type 2) tveeprom 0-0050: TV standards NTSC(M) (eeprom 0x08) tveeprom 0-0050: audio processor is MSP4448 (idx 27) tveeprom 0-0050: decoder processor is SAA7115 (idx 19) tveeprom 0-0050: has no radio, has no IR receiver, has no IR transmitter ivtv0: Autodetected Hauppauge WinTV PVR-250 ivtv0: Failed to load module tuner ivtv0: Failed to load module saa7115 ivtv0: Failed to load module msp3400 ivtv0: Registered device video0 for encoder MPG (4096 kB) ivtv0: Registered device video32 for encoder YUV (2048 kB) ivtv0: Registered device vbi0 for encoder VBI (1024 kB) ivtv0: Registered device video24 for encoder PCM (320 kB) ivtv0: Initialized card #0: Hauppauge WinTV PVR-250 ivtv: End initialization cx23885 driver version 0.0.1 loaded ACPI: PCI Interrupt Link [LNEA] enabled at IRQ 17 ACPI: PCI Interrupt 0000:03:00.0[A] -> Link [LNEA] -> GSI 17 (level, low) -> IRQ 17 CORE cx23885[0]: subsystem: 0070:7911, board: Hauppauge WinTV-HVR1250 [card=3,autodetected] cx23885[0]: i2c bus 0 registered tuner' 2-0043: chip found @ 0x86 (cx23885[0]) tda9887 2-0043: tda988[5/6/7] found cx23885[0]: i2c bus 1 registered msp3400' 3-0044: MSP7468D-4 found @ 0x88 (cx23885[0]) msp3400' 3-0044: MSP7468D-4 mode is autodetect cx23885[0]: i2c bus 2 registered tveeprom 1-0050: Encountered bad packet header [ff]. Corrupt or not a Hauppauge eeprom. cx23885[0]: warning: unknown hauppauge model #0 cx23885[0]: hauppauge eeprom: model=0 cx23885[0]: cx23885 based dvb card MT2131: successfully identified at address 0x61 DVB: registering new adapter (cx23885[0]) DVB: registering frontend 0 (Samsung S5H1409 QAM/8VSB Frontend)... cx23885_dev_checkrevision() Hardware revision = 0xc0 cx23885[0]/0: found at 0000:03:00.0, rev: 3, irq: 17, latency: 0, mmio: 0xfea00000 PCI: Setting latency timer of device 0000:03:00.0 to 64 Adding 506036k swap on /dev/sdb2. Priority:-1 extents:1 across:506036k r8169: eth0: link up eth0: no IPv6 routers present ivtv0: Loaded v4l-cx2341x-enc.fw firmware (376836 bytes) ivtv0: Loaded v4l-cx2341x-dec.fw firmware (262144 bytes) ivtv0: Encoder revision: 0x02060039 ivtv0: Decoder revision: 0x02020023 ivtv0: i2c addr 0x21 not found for command 0x4008646f ivtv0: i2c hardware 0x00000008 (msp3400) not found for command 0x4008646d _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
