irw doesn't output anything unless the correct settings are put in lircd.conf that's why you need to make sure you're detecting signals. run irrecord. when it asks to press a button, press a button and keep it down until it says you can release it. that way you can build your own lircd.conf. but 1st you need to make sure you are getting signals. strace lircd and check if it responds to anything when you push a button.
N. On Thu, 16 Dec 2004 09:42:40 -0500, Jeff Simpson <[EMAIL PROTECTED]> wrote: > Before I loaded the lirc_dev module, it would crash whenever I ran > irw. Now irw runs fine, but doesn't do anything. I run it, the logs > say that it established a connection. I ctrl-c irw, the logs say that > the connection closed, I can repeat this over and over, but irw never > outputs anything > > - Jeff > > On Thu, 16 Dec 2004 06:32:44 -0800 (PST), Thomas K. Nappi > <[EMAIL PROTECTED]> wrote: > > Does lircd die when you attempt to run irw? In my case, that is > > what was happening. > > > > Try this out. > > > > /sbin/service lircd restart > > tail -20 /var/log/messages > > /usr/bin/irw > > tail -20 /var/log/messages > > ------------------------------------------------------- > SF email is sponsored by - The IT Product Guide > Read honest & candid reviews on hundreds of IT Products from real users. > Discover which products truly live up to the hype. Start reading now. > http://productguide.itmanagersjournal.com/ > _______________________________________________ > Ivtv-users mailing list > [EMAIL PROTECTED] > https://lists.sourceforge.net/lists/listinfo/ivtv-users > ------------------------------------------------------- SF email is sponsored by - The IT Product Guide Read honest & candid reviews on hundreds of IT Products from real users. Discover which products truly live up to the hype. Start reading now. http://productguide.itmanagersjournal.com/ _______________________________________________ Ivtv-users mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/ivtv-users
