I have trouble running X via the output of the PVR-350. I have been following Jarod Wilsons MythTV guide for FC3. I have a new PVR-350 (where tda9887=0 is necessary) and I can capture video. My xorg.conf is Jarods modified with the correct PCI-bus id in decimal and with the glx module commented out. When I start the PC, X refuses to start because the framebuffer is missing. I then login, 'modprobe ivtv' and 'startx' and then the session hangs. The TV shows a X cursor in the middle and horizontal gray lines in the lower half of the display. The monitor (connected to a Radeon card) shows a message telling that the X configuration is wrong. I have looked in mailing lists and I am not sure if anyone has made the TV output of the new PVR-350 work. So my questions are now:
1. Has anyone made the TV output of the new PVR-350 work ? 2. Has anyone made it work on FC3 ? 3. Should I try to go back to FC2 instead ? 4. Should I buy a nVidia FX5200 instead ? My xorg.conf can be found on http://niels.dybdahl.dk/public/xorg.conf and my modprobe.conf can be found on http://niels.dybdahl.dk/public/modprobe.conf Best regards Niels Dybdahl ------------------------------------------------------- The SF.Net email is sponsored by: Beat the post-holiday blues Get a FREE limited edition SourceForge.net t-shirt from ThinkGeek. It's fun and FREE -- well, almost....http://www.thinkgeek.com/sfshirt _______________________________________________ Ivtv-users mailing list Ivtv-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/ivtv-users
