On 9 Oct 2008, at 14:06 , Rob Hamerling wrote:

>>
>> Two blink files refused to burn, I gave them a -1.
>
> What exactly means 'refused to burn'? Something with the programmer?

> G5-fiwihex:~/jalv2/jallib/unvalidated/sample/by_device/18f4620 eur$  
> xw go b18f4620.hex
> XWisp 1.30, command line mode
> hardware: Wisp628 1.23 (fast) (wisp648 firmware)
> target: 18f4620, device code 0C00 revision bits 06
>
> verification failure: different data at address 300000: file=FF  
> target=0
> ERROR

Three times in a row. I have seen this before.

The b18f4550 code blinks v-e-r-y  s-l-o-w.  If I set the freq at 20  
Mhz, it will run even slower.

> I'm very curious to know what goes wrong with you. The blink  
> samples for
> the 18F4620 and 18F2620 work here. I have no 18F4550, but an 18f4582
> works here too. So tend to believe there is something wrong with your
> test board.

The same board (ZIF socket) works just fine with a 16F877, 16F777 and  
an 18F452.

Yes, it is weird.


Could the impedance of the PLL-possible OSC pins matter here? I'll  
check if the PLL is default off.

If the PLL is on, blinking would occur faster, not slower.

---
ir EE van Andel [EMAIL PROTECTED]  http://www.fiwihex.nl
Fiwihex B.V. Wierdensestraat 74, NL7604BK Almelo, Netherlands
tel+31-546-491106 fax+31-546-491107



--~--~---------~--~----~------------~-------~--~----~
You received this message because you are subscribed to the Google Groups 
"jallib" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to [EMAIL PROTECTED]
For more options, visit this group at 
http://groups.google.com/group/jallib?hl=en
-~----------~----~----~----~------~----~------~--~---

Reply via email to