Does you/he use a sound recording program, or any other program that would take over the sounds? If this is going to be a frequent occurrence, you might need to become acquainted with whatever the cause of this situation is. otherwise, you will need sight to system-restore.
----- Original Message ----- From: "Patricia Dunbar" <[email protected]> To: <[email protected]> Sent: Monday, June 22, 2009 10:10 PM Subject: Re: [JAWS-Users] No Speech I did do all of that save the last part regarding Jaws here. I had those same steps from David Whitehead post when this happened the last time and I did the first part of your message after doing the run dialogue sndvol32 part, but still no sounds or speech. I seem to recall we had to do a system restore to bring it all back sigh. ----- Original Message ----- >From: "Flor Lynch" <[email protected]> To: <[email protected]> Sent: Monday, June 22, 2009 4:04 PM Subject: Re: [JAWS-Users] No Speech > >From what you wrote below, if that is exactly what you did, it appears > >you > did not complete the sequence. If you have no sound (and that is separate > from JAWS No Speech): In the Run dialog, type sndvol32; then tab once, > and > hit the home key to increase master Volume to 100%; and then tab once to > the > Mute All checkbox, which should be unchecked. press the spacebar to > change > its state to unchecked. perhaps now sound is restored. You can now > adjust > the volume, taking care *at all times* not to check any of the mute > checkboxes in these dialogues. > > If you have sound, but not JAWS speech: To get JAWS speech, press > JAWSKey+v, and then the end key, and then the enter key. that's a quick > way. > > ----- Original Message ----- > From: "Patricia Dunbar" <[email protected]> > To: "Users of Jaws" <[email protected]> > Sent: Monday, June 22, 2009 4:44 AM > Subject: [JAWS-Users] No Speech > > > Hello, > > We seem to have encountered once again Allen Dunbar has managed somehow to > not have any speech on his computer again... > > I was smart this time and saved the instructions from the time before and > have tried the Run command typing the, sndvol32 and enter, but still > nothing.. > > Now is there any way at all to do a system's restore without speech? > > Thanks, > > Patricia > > > For answers to frequently asked questions about this list visit: > http://www.jaws-users.com/help/ > > > For answers to frequently asked questions about this list visit: > http://www.jaws-users.com/help/ For answers to frequently asked questions about this list visit: http://www.jaws-users.com/help/ For answers to frequently asked questions about this list visit: http://www.jaws-users.com/help/
