Interesting that it works for everyone else. I have used all of the
suggestions before such as alt n and tabbing, but nothing reads anymore.
I'll kep looking. Perhaps screen resolution or a jaws repair ...
-----Original Message-----
From: TheHangMan
Sent: Tuesday, December 6, 2016 6:31 PM
To: [email protected]
Subject: Re: [JAWS-Users] user account settings in windows 10
Gene,
I tab, until the yes option sounds then press the spacebar,
Alt Y and alt N works to as mention.
Jorge
-----Original Message-----
From: JAWS-Users-List [mailto:[email protected]] On
Behalf Of John R Vaughn
Sent: Tuesday, December 06, 2016 8:33 PM
To: [email protected]
Subject: Re: [JAWS-Users] user account settings in windows 10
Jeane, to access the user control, I use alt key plus letter n as in nancy.
then I can tab through the control.
John in sunny and warm southwest florida
-----Original Message-----
From: JAWS-Users-List [mailto:[email protected]] On
Behalf Of Jean Menzies
Sent: Tuesday, December 06, 2016 7:43 PM
To: [email protected]
Subject: Re: [JAWS-Users] user account settings in windows 10
All good info, but I used to be able to actually read this window. Now the
whole window is blank so far as Jaws is concerned. I can read it with the
built-in OCR. I can use the various keystrokes, or some of them, that
everyone
has mentioned. But Jaws doesn't read the controls as I tab in this window.
Just wondering why.
Jean
-----Original Message-----
From: Gene Warner
Sent: Tuesday, December 6, 2016 3:52 PM
To: [email protected]
Subject: Re: [JAWS-Users] user account settings in windows 10
Hi Jean!
I usually use Alt+Y to answer yes, or Alt+N to answer no.
hth
Cheers!
On 12/6/2016 6:15 PM, [email protected] wrote:
Jean: I normally use the tab key. I am using JAWS 17, with Windows 10.
Am not certain if this will have any difference on your situation or not.
Jerry
-----Original Message----- From: Jean Menzies
Sent: Tuesday, December 6, 2016 4:42 PM
To: JawsUsersList
Subject: [JAWS-Users] user account settings in windows 10
Using Jaws 18 and Windows 10. When I run a program to install
updates, such as when installing Jaws updates, I get the typical pop
up message window that says something like 'Do you want to allow the
following program to make changes ...
Yes, I want that message. I hear it, but I can't navigate to the
window to choose yes. I can do it with NVDA. I used to be able to do
it with Jaws, but for a while now I haven't been able to do it. I
don't know if I have turned something off or what. Any ideas how to get
this
back?
Jean
For answers to frequently asked questions about this list visit:
http://www.jaws-users.com/help/
For answers to frequently asked questions about this list visit:
http://www.jaws-users.com/help/
For answers to frequently asked questions about this list visit:
http://www.jaws-users.com/help/
For answers to frequently asked questions about this list visit:
http://www.jaws-users.com/help/
For answers to frequently asked questions about this list visit:
http://www.jaws-users.com/help/
For answers to frequently asked questions about this list visit:
http://www.jaws-users.com/help/
For answers to frequently asked questions about this list visit:
http://www.jaws-users.com/help/
