I didn't think I could use sub-if when the main interface was setup as a switchport.
It works like that ... interface GigabitEthernet1/2 description blahblah switchport switchport trunk encapsulation dot1q switchport trunk allowed vlan 1,100,127 switchport mode trunk ! interface GigabitEthernet1/2.100 encapsulation dot1Q 100 no snmp trap link-status xconnect X.X.Y.110 803 encapsulation mpls ! -----Original Message----- From: Yevgeniy Voloshin [mailto:[EMAIL PROTECTED] Sent: Thursday, April 05, 2007 4:01 PM To: Christian Malo Cc: [email protected] Subject: Re: [j-nsp] juniper - cisco l2circuit problem Chris, I think on 7600/6500 you want use vlan-based EoMPLS, so xconnect must be configuresd on GigabitEthernet1/2 subinterface something like that interface GigabitEthernet1/2.100 encapsulation dot1Q 100 xconnect X.X.Y.100 803 encapsulation mpls no shut Useful CCO link: http://www.cisco.com/en/US/products/hw/routers/ps368/products_configuration_ guide_chapter09186a0080699477.html Confguration xconnect under interface Vlan100 works only on 3750ME! Also be sure that you add lo0.0(I mean X.X.Y.100) under protocols ldp section on juniper: set protocols ldp interface lo0.0 --- HTH, Yev. _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
