Christian, If you want to use EoMPLS xconnect on a SVI (to allow for local switching as well) then you need a OSM+/SIP400/SIP600/ES20 as the core facing interface. Without one of these modules, you can only configure the xconnext on a sub-interface or main interface.
Hope this helps, ----- Message d'origine ----- De: Christian Malo <[EMAIL PROTECTED]> Date: Jeudi, Avril 5, 2007 2:57 pm Objet: [j-nsp] juniper - cisco l2circuit problem À: [email protected] > I setup a basic l2circuit between a sup720 and an m20. > > Here's the IOS config and output > > interface GigabitEthernet1/2 > description blahblah > switchport > switchport trunk encapsulation dot1q > switchport trunk allowed vlan 1,100,127 > switchport mode trunk > > interface Vlan100 > no ip address > xconnect X.X.Y.110 803 encapsulation mpls > > Local interface: Vl100 up, line protocol up, Eth VLAN 100 up > Destination address: X.X.Y.110, VC ID: 803, VC status: down > Output interface: none, imposed label stack {794085} > Preferred path: not configured > Default path: active > Next hop: Invalid ADDR > Create time: 00:12:29, last status change time: 00:03:35 > Signaling protocol: LDP, peer X.X.Y.110:0 up > MPLS VC labels: local 38, remote 794085 > Group ID: local 0, remote 0 > MTU: local 1500, remote 1500 > Remote interface description: > Sequencing: receive disabled, send disabled > VC statistics: > packet totals: receive 0, send 0 > byte totals: receive 0, send 0 > packet drops: receive 0, send 0 > > > JunOS config and output > > unit 518 { > description "blahblah"; > encapsulation vlan-ccc; > vlan-id 518; > } > > neighbor X.X.Y.125 { > interface ge-0/3/0.518 { > virtual-circuit-id 803; > description "blahblah"; > no-control-word; > } > } > > Interface Type St Time last up > # Up trans > ge-0/3/0.518(vc 803) rmt Up Apr 5 14:39:41 2007 > 1 > Local interface: ge-0/3/0.518, Status: Up, Encapsulation: VLAN > Remote PE: X.X.Y.125, Negotiated control-word: No > Incoming label: 794085, Outgoing label: 38 > Time Event > Interface/Lbl/PE Apr 5 14:39:41 2007 status update timer > Apr 5 14:39:39 2007 PE route changed > Apr 5 14:39:39 2007 Out lbl Update > 38 > Apr 5 14:39:39 2007 In lbl Update > 794085 Apr 5 14:39:39 2007 loc intf up > ge-0/3/0.518 > > > > LDP session comes up ... it works with ethernet-vlan > configurations but > the second I try on vlan interfaces, I get that > > > > thanks for the help. > > > -chris > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp > _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
