Alex, Is there some way to avoid or to change this default value ?
It is possible to configure a firewall-filter to increase these values ? The problem is that when our customers start TRACES outside ... they think our network as problems. Thanks a lot, Giuliano > Giuliano, > On Juniper M-series, there is an ICMP TTL-exceeded rate-limit in place: > 50 pps per logical interface and 500 pps per box. > See http://puck.nether.net/pipermail/cisco-nsp/2006-June/031717.html > Rgds > Alex > > ----- Original Message ----- From: "Giuliano Cardozo Medalha" > <[EMAIL PROTECTED]> > To: <[email protected]> > Sent: Saturday, April 21, 2007 8:51 PM > Subject: [j-nsp] M7i and M10i problems - TRACE ROUTE > > >> People, >> >> We have a Juniper M10i border router. >> >> When we install this router on our network ... we are having problems >> with MTR and traceroute programs. >> >> Basically ... every trace that pass trough the router lose 70% of the >> packets. >> >> PING just works fine ... but TRACE and MTR not. >> >> Juniper saids in J-TAC that this is a default config (FACTORY DEFAULT) >> from the router. >> >> There is some command or way to change this behavior ? >> >> Thanks a lot, >> >> Giuliano >> >> _______________________________________________ >> juniper-nsp mailing list [email protected] >> https://puck.nether.net/mailman/listinfo/juniper-nsp > > _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
