Usually you need wait a few minutes until all interfaces are deleted. Then the right command to remove the bulk config is:
no vlan bulk-config "test" HTH ./diogo -montagner On Fri, Jan 18, 2008 at 10:10 AM, SunnyDay <[email protected]> wrote: > Hello > In junose ihave this configuration on an interface: > > i/nterface gigabitEthernet 1/0/1 > shutdown > mtu 1522 > encapsulation vlan > vlan bulk-config "test" > profile vlan bulk-config "test" "test pro" > vlan bulk-config "test" vlan-range 567 667 > > /my problem is that the interface is shutdown but i still have vlan > subinterface,pppoe interface and ppp in down state > and i cannot remove the "/vlan bulk-config "test" vlan-range 567 667" /from > the interface because it says:/dynamic interface exists > > any ideas? > / > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp > _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
