I see the same thing on fresh configs - once I define something on one of those interfaces, it shows up.
Dan Farrell Sent from my iPhone On Aug 6, 2010, at 4:45 PM, "Stefan Fouant" <[email protected] > wrote: >> -----Original Message----- >> From: [email protected] [mailto:juniper-nsp- >> [email protected]] On Behalf Of snort bsd >> Sent: Friday, August 06, 2010 3:01 PM >> To: juniper-nsp >> Subject: [j-nsp] virtual-chassis and interfaces >> >> Hi all: >> >> With virtual-chassis, after I login, I only see interfaces (under >> stanza "interfaces") on master, not those interfaces on the back up >> mode or line card mode. >> >> How could I configure those interfaces that are not on master? do I >> have to login each physical switch in order to configure those >> interfaces? > > They might not necessarily show up in the configuration until you > actually > define them... it depends on how they were brought into the virtual- > chassis. > However if your Virtual-Chassis is set up correctly, they should > still show > up when you do a 'show interfaces terse'. The FPC portion of the > interface > naming convention is what is used to identify the interfaces on a > given > virtual-chassis member. In other words, interfaces on member-id 2 > will show > up in 'show interfaces terse' as ge-2/x/x or xe-2/x/x. > > You can verify that your virtual-chassis is working correctly by > doing a > 'show virtual-chassis status', or even a 'show chassis hardware' > will give > you a clue as to whether or not all the members are shown in the > virtual-chassis. > > HTHs. > > Stefan Fouant, CISSP, JNCIEx2 > www.shortestpathfirst.net > GPG Key ID: 0xB5E3803D > > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
