Ok,
It looks like a hardware problem (at PIC or EFEB level, may be).
I´d be a good idea to change the cable too.... just in case....
Check with show log chassid , may be you can find some log related to a
physical problem.
Also check with a show route logical-router PE2 or PE3. You must find
your subnets and physical addresses of your interfaces. If you find some
route marked as rejected you could think in some problem of connectivity
in L1.
Good luck
logo impre
Ing. Cristian Frizziero
Honorio Pueyrredon 1475 -- Buenos Aires
Tel+54.11.4855.6041 (Ext.517)
Cel+54.9.11.6249.1303
[email protected] <mailto:[email protected]>
www.iquall.net <http://www.iquall.net>
El 21/12/2010 18:34, juniper light escribió:
I didn't change cabling, but I connected a new interface to annother
router and I'm having the same problem, the new interface is in the
default configuration :
set interfaces fe-0/3/2 unit 0 family inet address 10.0.24.2/30
<http://10.0.24.2/30>
ad...@m10 <mailto:ad...@m10>> show interfaces terse
Interface Admin Link Proto Local Remote
...
fe-0/3/0 up up
fe-0/3/0.123 up up inet 10.0.123.1/30
<http://10.0.123.1/30>
fe-0/3/0.32767 up up
fe-0/3/1 up up
fe-0/3/1.123 up up inet 10.0.123.2/30
<http://10.0.123.2/30>
fe-0/3/1.32767 up up
fe-0/3/2 up up
fe-0/3/2.0 up up inet 10.0.24.2/30 <http://10.0.24.2/30>
fe-0/3/3 up up
any idea guys ?
BR // Mounir
On Tue, Dec 21, 2010 at 7:25 PM, Cristian Frizziero
[email protected] <mailto:[email protected]>
wrote:
Hi!!
I'd try to change ports pairs, and to switch the PIC to a
different fpc slot, just to be sure that there is no hardware
issue....
The configuration looks fine....
Cristian
El 21/12/2010 15:07, juniper light escribió:
Hi guys, I would like to use M10 to simulate 3 PE, using
logical-routers ( Junos 8.4R4.2 ) I connected 2 fastethernet
back-to-back, link are UP. but when I tried configuring vlan-id ,
I cannot ping from one Logical router to the other : first
scenario using Vlan-tagging : set logical-routers PE2 interfaces
fe-0/3/0 unit 23 vlan-id 123 set logical-routers PE2 interfaces
fe-0/3/0 unit 23 family inet address 10.0.123.1/30
<http://10.0.123.1/30> set logical-routers PE3 interfaces
fe-0/3/1 unit 23 vlan-id 123 set logical-routers PE3 interfaces
fe-0/3/1 unit 23 family inet address 10.0.123.2/30
<http://10.0.123.2/30> set interfaces fe-0/3/0 vlan-tagging set
interfaces fe-0/3/1 vlan-tagging ad...@m10> show interfaces terse
Interface Admin Link Proto Local Remote ... fe-0/3/0 up up
fe-0/3/0.123 up up inet 10.0.123.1/30 fe-0/3/0.32767
<http://10.0.123.1/30fe-0/3/0.32767> up up fe-0/3/1 up up
fe-0/3/1.123 up up inet 10.0.123.2/30 fe-0/3/1.32767
<http://10.0.123.2/30fe-0/3/1.32767> up up fe-0/3/2 up up
fe-0/3/3 up up Second scenario without Vlan-tagging : set
logical-routers PE2 interfaces fe-0/3/0 unit 0 family inet
address 10.0.123.1/30 <http://10.0.123.1/30> set logical-routers
PE3 interfaces fe-0/3/1 unit 0 family inet address 10.0.123.2/30
<http://10.0.123.2/30> ad...@m10> ping logical-router PE2
10.0.123.2 source 10.0.123.1 PING 10.0.123.2 (10.0.123.2): 56
data bytes nothing happen ...... ad...@m10> show interfaces terse
Interface Admin Link Proto Local Remote ... fe-0/3/0 up up
fe-0/3/0.0 up up inet 10.0.123.1/30 fe-0/3/1
<http://10.0.123.1/30fe-0/3/1> up up fe-0/3/1.0 up up inet
10.0.123.2/30 fe-0/3/2 <http://10.0.123.2/30fe-0/3/2> up up
fe-0/3/3 up up ad...@m10
> show chassis hardware
Hardware inventory:
Item Version Part number Serial number Description
Chassis xxxx M10
Midplane REV 03 710-001950 xxx M10 Backplane
Power Supply A Rev 05 740-002497 xxx AC Power Supply
Display REV 04 710-001995 xxx M10 Display Board
Routing Engine REV 07 740-007603 xxx RE-3.0
FEB REV 08 710-003310 xx E-FEB
FPC 0 E-FPC
PIC 1 REV 05 750-003163 xxx 1x G/E, 1000 BASE-SX
PIC 3 REV 06 750-002992 xxx 4x F/E, 100 BASE-TX
FPC 1 E-FPC
Fan Tray Rear Left Fan Tray
Any idea about that ?
Thanks for your help,
Kind Regards
// Mounir
_______________________________________________
juniper-nsp mailing [email protected]
<mailto:[email protected]>
https://puck.nether.net/mailman/listinfo/juniper-nsp
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
