Haven't had that issue, but you can get around it. Just run the command and pipe it to a file. Then you can scp it off.
show config | save filename start shell scp filename user@server:/path Will On May 31, 2011, at 3:18 PM, Muhammad Adnan Mohsin wrote: > Hi Experts, > I have a MX240 router installed at a remote location. I am able to > telnet/SSH the router but when I run a command that needs to return a > large output (e.g. show log messages or show conf) the session hangs > and then I have to re-establish the connection. Because of this I > couldn't provide some outputs that were required by JTAC. As long as > the commands I give on the router don't have to return a large output, > the session remains intact. The current code that I am running is > 10.2R3.10. JTAC has recommended me to install 10.3R2 but I have a > feeling that won't work. Has somebody experience a similar issue? I > would appreciate if somebody could give me some guidance to > troubleshoot this problem. > > thanks. > Adnan. > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp Will O'Brien University of Missouri, DoIT DNPS Network Systems Analyst - Redacted [email protected] _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
