the show bgp neighbor (neighborip)
on the juniper will tell you how many it's sending. e.g. an example
session...
Active prefixes: 64903
Received prefixes: 374540
Accepted prefixes: 374538
Suppressed due to damping: 0
Advertised prefixes: 3
On 10/21/11 09:15 , Loopback EZ wrote:
> I am replacing an old Cisco router with a Brocade MLX as IBGP peer to a
> Juniper M10. I am only getting 250K routes and I have NO filtering
> enabled. I know that the Juniper is receiving a full EBGP route table
> but is only passing 250K to any of its internal IBGP peers including the
> old Cisco. Suspect that there is route summarization happening so it
> would not overrun an old Cisco SUP module. Where should I look for
> summarization or any other possible cause in the Juniper config?
>
>
> _______________________________________________
> juniper-nsp mailing list [email protected]
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
