I am not sure about exact Brocade command,
but do you have BGP "prefix-limit" enabled on Brocade?
Rgds
Alex
----- Original Message -----
From: "Loopback EZ" <[email protected]>
To: <[email protected]>
Sent: Friday, October 21, 2011 5:15 PM
Subject: [j-nsp] Unfamiliar with Juniper M10 Config Files
I am replacing an old Cisco router with a Brocade MLX as IBGP peer to a
Juniper M10. I am only getting 250K routes and I have NO filtering
enabled. I know that the Juniper is receiving a full EBGP route table
but is only passing 250K to any of its internal IBGP peers including the
old Cisco. Suspect that there is route summarization happening so it
would not overrun an old Cisco SUP module. Where should I look for
summarization or any other possible cause in the Juniper config?
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
