Also, I might be wrong, but doesn't the RSP4G limit the per slot cap to 40g in a single RSP (failure) scenario? That rules out your max 8x10G line rate.
Again I could be wrong, I'm going off of memory. On Apr 24, 2012, at 6:45 PM, Skeeve Stevens <[email protected]> wrote: > Does that put the cost comparison out of alignment? > > *Skeeve Stevens, CEO* > eintellego Pty Ltd > [email protected] ; www.eintellego.net <http://www.eintellego.net.au> > > Phone: 1300 753 383 ; Fax: (+612) 8572 9954 > > Cell +61 (0)414 753 383 ; skype://skeeve > > facebook.com/eintellego > > twitter.com/networkceoau ; www.linkedin.com/in/skeeve > > PO Box 7726, Baulkham Hills, NSW 1755 Australia > > The Experts Who The Experts Call > Juniper - Cisco – Brocade - IBM > > > > On Wed, Apr 25, 2012 at 09:31, Phil Bedard <[email protected]> wrote: > >> If you are using the newer RSP440 and newer linecards it is substantially >> higher, 2M+ IPv4. But you are right the first gen cards the original >> poster had speced only support 512K in the FIB and we are at 400K+ now in >> the Internet table. >> >> Phil >> >> On Apr 24, 2012, at 12:41 PM, Doug Hanks <[email protected]> wrote: >> >>> The last time I looked the ASR9K still had a small FIB and tapped out at >>> around 500K. >>> >>> Thank you, >>> >>> -- >>> Doug Hanks - JNCIE-ENT #213, JNCIE-SP #875 >>> Sr. Systems Engineer >>> Juniper Networks >>> >>> >>> On 4/24/12 8:55 AM, "Peter" <[email protected]> wrote: >>> >>>> Hi >>>> >>>> I have to upgrade my bgp routers, i have budget for two options: >>>> >>>> 1. >>>> - bundle: MX240BASE-AC-HIGH, MPC1-3D-R-B, MIC-3D-20XGE-SFP, >>>> MIC-3D-2XGE-XFP; configurable RE, SCB, and PEM >>>> - better routing engine RE-S-1800X2-8G-UPG-BB + jflow license ( netflow >>>> v9 or ipfix) S-ACCT-JFLOW-IN >>>> >>>> or >>>> >>>> 2. asr 9006 >>>> - A9K-RSP-4G >>>> - A9K-MOD80-TR, 80G Modular Linecard, Packet Transport Optimized >>>> - license for l3 vpn >>>> >>>> the price is almost the same. I need: >>>> >>>> - ports: from 4x10G line to max 8x10G, line rate >>>> - 3 virtual routers with full ip routing table v4 >>>> - 10 virtual routers with ca 10k prefix in routing table v4 >>>> - v6 >>>> - up to 12 full bgp feed >>>> - netflow v9 or ipfix, sampling max 100/s >>>> - define counters on logical and physical interfaces, count many times >>>> to the same counter, one packet could be count to different counters in >>>> next term >>>> - access to counters via snmp >>>> - independent control plane and data plane >>>> - and few others things on bgp edge >>>> >>>> which model will be better ? >>>> thanks for some advice >>>> >>>> regards >>>> Peter >>>> >>>> _______________________________________________ >>>> juniper-nsp mailing list [email protected] >>>> https://puck.nether.net/mailman/listinfo/juniper-nsp >>> >>> >>> _______________________________________________ >>> juniper-nsp mailing list [email protected] >>> https://puck.nether.net/mailman/listinfo/juniper-nsp >> >> _______________________________________________ >> juniper-nsp mailing list [email protected] >> https://puck.nether.net/mailman/listinfo/juniper-nsp >> > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
