Here are some more errors if it helps
tunefs: soft updates remains unchanged as disabled Creating initial configuration...Interface control process: /usr/libexec/ld-elf.so.1: Shared object "libcrypto.so.3" not found, required by "cgatool" umass0: at uhub0 port 3 (addr 2) disconnected (da0:umass-sim0:0:0:0): lost device g_vfs_done():da0s1a[WRITE(offset=8192, length=2048)]error = 6 umass0: detached umass1: at uhub0 port 2 (addr 3) disconnected (da1:umass-sim1:1:0:0): lost device g_vfs_done():da1s1f[WRITE(offset=8192, length=2048)]error = 6 mgd: warning: panic: vinvalbuf: dirty bufs Uptime: 1m29s (da0:dead_sim0:0:0:0): Synchronize cache failed, status == 0x8, scsi status == 0x0 (da1:dead_sim0:0:0:0): Synchronize cache failed, status == 0x8, scsi status == 0x0 Cannot dump. No dump device defined. Automatic reboot in 15 seconds - press a key on the console to abort *Ali Sumsam CCIE* *Network Engineer - Level 3* eintellego Pty Ltd [email protected] ; www.eintellego.net Phone: 1300 753 383 ; Fax: (+612) 8572 9954 Cell +61 (0)410 603 531 facebook.com/eintellego PO Box 7726, Baulkham Hills, NSW 1755 Australia The Experts Who The Experts Call Juniper - Cisco – Brocade - IBM On Thu, Nov 29, 2012 at 12:21 PM, Ali Sumsam <[email protected]>wrote: > Hi, > > My new MX5 died today. If I try to boot it up, it stuck at following > message. > > U-Boot 1.1.6 (Jun 10 2011 - 00:50:30) > > CPU: 8572, Version: 2.1, (0x80e00021) > Core0: E500, Version: 3.0, (0x80210030) > Clock Configuration: > CPU0:1333 MHz, CPU1:1333 MHz, CCB: 533 MHz, > DDR: 267 MHz (533 MT/s data rate) (Synchronous), LBC: 33 MHz > L1: D-cache 32 kB enabled > I-cache 32 kB enabled > Board: MX5-T 1.8 > CPLD: Version 0x1f > DRAM: Initializing - DDR: 2048 MB > Testing DRAM from 0x00000000 to 0x80000000 > DRAM test phase 1: > DRAM test fails at: 7ff63e24 > hang at function = 0xfffbe504 > ### ERROR ### Please RESET the board ### > > > Any suggestions? > > Regards, > > *Ali Sumsam CCIE* > *Network Engineer - Level 3* > eintellego Pty Ltd > [email protected] ; www.eintellego.net > > Phone: 1300 753 383 ; Fax: (+612) 8572 9954 > > Cell +61 (0)410 603 531 > > facebook.com/eintellego > PO Box 7726, Baulkham Hills, NSW 1755 Australia > > The Experts Who The Experts Call > Juniper - Cisco – Brocade - IBM > > _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
