Thanks but this is pure layer2 deployments (typically). I should have clarified that.... some of the VLAN's have IP but most are to link buildings together within a metro etc....
Really, this is more of a metro ethernet type of environment..... I'll read up again on this but I'm comparing this against a tried and true Cisco solution we've used many times and it just worked (rather simply too)..... with what I've seen/read so far on the Juniper front, this is going to be a problem to implement - really hoping someone can prove me wrong though ;) Paul -----Original Message----- From: Per Granath [mailto:[email protected]] Sent: January-10-13 9:18 AM To: Paul Stewart; [email protected] Subject: RE: [j-nsp] EX Switch Question The general idea is to do: Policing (firewall filter) on ingress Shaping (CoS) on egress http://www.juniper.net/us/en/local/pdf/implementation-guides/8010073-en.pdf Shaping is typically per port, and I am not sure if you can do that per VLAN. But the feature guide say there is CoS support on RVIs... https://www.juniper.net/techpubs/en_US/release-independent/junos/topics/conc ept/ex-series-software-features-overview.html#cos-features-by-platform-table In that case, the EX4200 virtual chassis seems good. -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Paul Stewart Sent: Thursday, January 10, 2013 3:04 PM To: [email protected] Subject: [j-nsp] EX Switch Question Per port ingress and egress bandwidth control (rate limiting with burst) Per VLAN ingress and egress bandwidth control (rate limiting on a per VLAN basis with burst) _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
