Peter, Would an aggregate interface assist in this? If It can be done in your logical scheme, the aggregate interface would provide a simple way to apply the entire X bandwidth no matter the pipes up.
Thank you, *Levi Pederson* Mankato Networks LLC cell | 612.481.0769 work | 612.787.7392 [email protected] On Wed, Apr 8, 2015 at 7:39 AM, Peter Ehiwe <[email protected]> wrote: > have you considered writing an event script for this ? > > On Tue, Apr 7, 2015 at 10:15 PM, Matthew Crocker > <[email protected]> wrote: > > > > Hello, > > > > A customer with two connections to my mx240. I want to police their > total bandwidth to 800mbps. Right now I have a 800mbps policer but that > gives them 800mbps on each circuit. > > > > Customer Interface 1 is a VLAN on a 10G interface > > Customer Interface 2 is a VLAN on a 1G interface > > > > Each interface has its own /30 IP subnet with a BGP session on each > customer IP > > > > Customer buys X bandwidth we want to give them X bandwidth over a pair > of circuits. If one circuit goes down the policer needs to be set to the X > bandwidth the purchased. > > > > Thanks > > > > -Matt > > > > -- > > Matthew S. Crocker > > President > > Crocker Communications, Inc. > > PO BOX 710 > > Greenfield, MA 01302-0710 > > > > E: [email protected] > > P: (413) 746-2760 > > F: (413) 746-3704 > > W: http://www.crocker.com > > > > > > > > > > _______________________________________________ > > juniper-nsp mailing list [email protected] > > https://puck.nether.net/mailman/listinfo/juniper-nsp > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp > _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
