That's right. EX4500 series is different and supports a bunch more MPLS features :)
Which I just noticed that since 12.2 apparently MPLS over RVI's and layer 3 sub-interfaces is apparently supported. On Tue, May 12, 2015 at 8:22 PM, Raphael Mazelier <[email protected]> wrote: > > > Le 12/05/15 10:27, Mark Tees a écrit : >> >> l2circuit is not supported as that requires a two label stack to work. >> >> EX4200's can only switch a 1 label stack. Any traffic passed in P/LSR >> fashion that has more than 1 label in the stack gets dropped >> transparently from what I have seen, regardless of what the control >> plane/RE said. >> >> ccc/remote-interface-switch like in the link I sent earlier is the >> only way that works as far as I have seen. This is probably because of >> the 1:1 mapping of LSP to ccc direction. >> > > Strange, because what I tested on Ex4550 is the opposite : > l2circuit are working, ccc not. > > -- > Raphael Mazelier -- Regards, Mark L. Tees _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
