Thanks mate for the help Actually , am stuck at the => and cannot reach the loader I hit boot and nothing happened setenv loaderdev net (without = because it gave me bad character) reset and again stuck in =>
On Sun, 11 Nov 2018 at 07:59, Jonas Frey <[email protected]> wrote: > Are you stuck at the "=>" Uboot prompt or are able to reach loader>? > From loader> it should be pretty straight forward to reinstall junos > from a install media. > > If you are stuck at "=>" then try: > boot > (should put you into loader>) > > Or: > setenv loaderdev=net > reboot > (this should try to load via net, however it can take some time untill > it works - just be patient) > > Or: > setenv loaderdev usb1:0 > boot > (should force to load from usb1) > > > If you have a 2nd (same) SRX you could also try to do a "snapshort > media usb factory" to the USB stick and afterwards insert that stick > into the faulty SRX and force it to boot from there. > > > > Am Sonntag, den 11.11.2018, 14:43 +0200 schrieb Mohammad Khalil: > > Ops , but it did not work either > > Nand format failed > > > > BR, > > Mohammad > > > > On Sun, 11 Nov 2018 at 14:46, Jonas Frey <[email protected]> > > wrote: > > > Hi Mohammad, > > > > > > thats a typo, its nand_format (note the underscore). > > > Am Sonntag, den 11.11.2018, 05:31 -0500 schrieb Mohammad Khalil: > > > > => reset > > > > > > > > > > > > U-Boot 1.1.6-JNPR-2.7 (Build time: Nov 26 2013 - 19:04:49) > > > > > > > > Initializing memory this may take some time... > > > > Measured DDR clock 266.62 MHz > > > > SRX_100H2 board revision major:1, minor:0, serial #: BZ4214AF1453 > > > > OCTEON CN5020-SCP pass 1.1, Core clock: 500 MHz, DDR clock: 266 > > > MHz > > > > (532 > > > > Mhz data rate) > > > > DRAM: 2048 MB > > > > Starting Memory POST... > > > > Checking datalines... OK > > > > Checking address lines... OK > > > > Checking 512K memory for U-Boot... OK. > > > > Running U-Boot CRC Test... OK. > > > > Flash: 4 MB > > > > USB: scanning bus for devices... 4 USB Device(s) found > > > > scanning bus for storage devices... Read Error for > > > > STMicroelectronics device 0 > > > > Not intializing this device, disabling autoboot > > > > Device may need formatting, please issue command : > > > > <nand_format> at console prompt to format > > > > 2 Storage Device(s) found > > > > Clearing DRAM........ done > > > > BIST check passed. > > > > Boot Media: nand-flash usb > > > > Net: pic init done (err = 0)octeth0 > > > > POST Passed > > > > Press SPACE to abort autoboot in 1 seconds > > > > => nand-format > > > > Unknown command 'nand-format' - try 'help' > > > > > > > > > > > > On Sun, 11 Nov 2018 at 04:17, Muhammad Atif Jauhar <atif.jauhar@g > > > mail > > > > .com> > > > > wrote: > > > > > > > > > > > > > > Hi Khalil, > > > > > > > > > > Kindly follow below link to recover it. > > > > > > > > > > > > > > > https://forums.juniper.net/t5/SRX-Services-Gateway/Boot-problem > > > -of- > > > > > UBoot-srx240-having-status-LED-red/td-p/211103 > > > > > > > > > > Regards, > > > > > > > > > > Muhammad Atif Jauhar > > > > > (+966-56-00-04-985) > > > > > > > > > > > > > > > On Sun, Nov 11, 2018 at 11:36 AM Mohammad Khalil <eng.mssk@gmai > > > l.co > > > > > m> > > > > > wrote: > > > > > > > > > > > > > > > > > Hello all > > > > > > I have my Juniper SRX 100h stuck in the u-boot mode > > > > > > I have tried to download a new image on a USB stick , plugged > > > it > > > > > > into the > > > > > > device and tried to upgrade with no luck > > > > > > Looked around but could not find a solution , anyone can help > > > > > > please? > > > > > > > > > > > > BR, > > > > > > Mohammad > > > > > > _______________________________________________ > > > > > > juniper-nsp mailing list [email protected] > > > > > > https://puck.nether.net/mailman/listinfo/juniper-nsp > > > > > > > > > > _______________________________________________ > > > > juniper-nsp mailing list [email protected] > > > > https://puck.nether.net/mailman/listinfo/juniper-nsp > > > > _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
