Dears I have formatted the USB using FAT32 , placed the image Physical reset took place and now the nand_format is repeating itself !
On Sun, 11 Nov 2018 at 15:12, Mohammad Khalil <[email protected]> wrote: > Thanks mate for the help > Actually , am stuck at the => and cannot reach the loader > I hit boot and nothing happened > setenv loaderdev net (without = because it gave me bad character) > reset > and again stuck in => > > On Sun, 11 Nov 2018 at 07:59, Jonas Frey <[email protected]> wrote: > >> Are you stuck at the "=>" Uboot prompt or are able to reach loader>? >> From loader> it should be pretty straight forward to reinstall junos >> from a install media. >> >> If you are stuck at "=>" then try: >> boot >> (should put you into loader>) >> >> Or: >> setenv loaderdev=net >> reboot >> (this should try to load via net, however it can take some time untill >> it works - just be patient) >> >> Or: >> setenv loaderdev usb1:0 >> boot >> (should force to load from usb1) >> >> >> If you have a 2nd (same) SRX you could also try to do a "snapshort >> media usb factory" to the USB stick and afterwards insert that stick >> into the faulty SRX and force it to boot from there. >> >> >> >> Am Sonntag, den 11.11.2018, 14:43 +0200 schrieb Mohammad Khalil: >> > Ops , but it did not work either >> > Nand format failed >> > >> > BR, >> > Mohammad >> > >> > On Sun, 11 Nov 2018 at 14:46, Jonas Frey <[email protected]> >> > wrote: >> > > Hi Mohammad, >> > > >> > > thats a typo, its nand_format (note the underscore). >> > > Am Sonntag, den 11.11.2018, 05:31 -0500 schrieb Mohammad Khalil: >> > > > => reset >> > > > >> > > > >> > > > U-Boot 1.1.6-JNPR-2.7 (Build time: Nov 26 2013 - 19:04:49) >> > > > >> > > > Initializing memory this may take some time... >> > > > Measured DDR clock 266.62 MHz >> > > > SRX_100H2 board revision major:1, minor:0, serial #: BZ4214AF1453 >> > > > OCTEON CN5020-SCP pass 1.1, Core clock: 500 MHz, DDR clock: 266 >> > > MHz >> > > > (532 >> > > > Mhz data rate) >> > > > DRAM: 2048 MB >> > > > Starting Memory POST... >> > > > Checking datalines... OK >> > > > Checking address lines... OK >> > > > Checking 512K memory for U-Boot... OK. >> > > > Running U-Boot CRC Test... OK. >> > > > Flash: 4 MB >> > > > USB: scanning bus for devices... 4 USB Device(s) found >> > > > scanning bus for storage devices... Read Error for >> > > > STMicroelectronics device 0 >> > > > Not intializing this device, disabling autoboot >> > > > Device may need formatting, please issue command : >> > > > <nand_format> at console prompt to format >> > > > 2 Storage Device(s) found >> > > > Clearing DRAM........ done >> > > > BIST check passed. >> > > > Boot Media: nand-flash usb >> > > > Net: pic init done (err = 0)octeth0 >> > > > POST Passed >> > > > Press SPACE to abort autoboot in 1 seconds >> > > > => nand-format >> > > > Unknown command 'nand-format' - try 'help' >> > > > >> > > > >> > > > On Sun, 11 Nov 2018 at 04:17, Muhammad Atif Jauhar <atif.jauhar@g >> > > mail >> > > > .com> >> > > > wrote: >> > > > >> > > > > >> > > > > Hi Khalil, >> > > > > >> > > > > Kindly follow below link to recover it. >> > > > > >> > > > > >> > > > > https://forums.juniper.net/t5/SRX-Services-Gateway/Boot-problem >> > > -of- >> > > > > UBoot-srx240-having-status-LED-red/td-p/211103 >> > > > > >> > > > > Regards, >> > > > > >> > > > > Muhammad Atif Jauhar >> > > > > (+966-56-00-04-985) >> > > > > >> > > > > >> > > > > On Sun, Nov 11, 2018 at 11:36 AM Mohammad Khalil <eng.mssk@gmai >> > > l.co >> > > > > m> >> > > > > wrote: >> > > > > >> > > > > > >> > > > > > Hello all >> > > > > > I have my Juniper SRX 100h stuck in the u-boot mode >> > > > > > I have tried to download a new image on a USB stick , plugged >> > > it >> > > > > > into the >> > > > > > device and tried to upgrade with no luck >> > > > > > Looked around but could not find a solution , anyone can help >> > > > > > please? >> > > > > > >> > > > > > BR, >> > > > > > Mohammad >> > > > > > _______________________________________________ >> > > > > > juniper-nsp mailing list [email protected] >> > > > > > https://puck.nether.net/mailman/listinfo/juniper-nsp >> > > > > > >> > > > _______________________________________________ >> > > > juniper-nsp mailing list [email protected] >> > > > https://puck.nether.net/mailman/listinfo/juniper-nsp >> > > >> > _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
