Greg,
Well…. I’m so embarrassed! That was it. Thanks again for your help. Bob From: [email protected] [mailto:[email protected]] On Behalf Of Greg Dyess Sent: Wednesday, June 24, 2009 12:23 PM To: [email protected] Subject: Re: [kicad-users] Bad Bus Label error message when making netlist Try changing the label to A_BUS[0..15] instead of A_BUS[0,15] (Note the ".." instead of ","). In addition, I will load up your schematic and try to see what I can see. Greg _____ From: Bob Shaffer <[email protected]> To: [email protected] Sent: Wednesday, June 24, 2009 9:13:47 AM Subject: RE: [kicad-users] Bad Bus Label error message when making netlist [1 Attachment] [ <http://us.mg4.mail.yahoo.com/dc/blank.html?bn=1357.22&.intl=us&.lang=en-US#TopText> Attachment(s) from Bob Shaffer included below] Greg, I appreciate you taking the time to help me! The attached files represent a simple test design that illustrate my problem. When I try to connect the two sheets together by drawing a Bus between A_BUS[0,15] on Sheet A to A_BUS[0,15] on Sheet B I get a popup error message “Bad Bus Label”. If I ignore the message and attempt to generate a netlist, I get the same error message. Bob From: [email protected] [mailto:[email protected]] On Behalf Of Greg Dyess Sent: Wednesday, June 24, 2009 9:23 AM To: [email protected] Subject: Re: [kicad-users] Bad Bus Label error message when making netlist My initial guesses would be: 1. You used a local label instead of a global label or net name. 2. Somehow numbers were not the last characters in the individual nets or the bus was not the prefix of the net names. 3. Buses in KiCAD are not like computer busses. Only nets with the same prefix followed by numbers are allowed in the bus. A0, A1, A2 in bus A[0..2] is a valid bus but WR, RD, CLK in bus Control is not valid. (I did all of the above starting out) It's difficult to analyze without seeing what you have done. If you email me directly with the archived project files I can load it up and see. Greg _____ From: mmabshaffer <[email protected]> To: [email protected] Sent: Tuesday, June 23, 2009 5:02:04 PM Subject: [kicad-users] Bad Bus Label error message when making netlist I just tried using KiCad for capturing a schematic and all went well until I tried to generate the netlist. I get a "Bad Bus Label" error popup message for each bus. The design is a hierarchical design with busses going between sheets. Can anyone give me a hint as to what I am doing wrong? ------------------------------------ Please read the Kicad FAQ in the group files section before posting your question. Please post your bug reports here. They will be picked up by the creator of Kicad. Please visit http://www.kicadlib.org <http://www.kicadlib.org/> for details of how to contribute your symbols/modules to the kicad library. For building Kicad from source and other development questions visit the kicad-devel group at http://groups.yahoo.com/group/kicad-develYahoo! Groups Links Attachment(s) from Bob Shaffer 1 of 1 File(s) Image removed by sender. TestBoard.zip <http://d.yimg.com/kq/groups/16027698/1772850888/name/TestBoard.zip>
<<~WRD000.jpg>>
<<image001.jpg>>
<<image002.jpg>>
