Every connection you make should have a wire in the rats nest. Have you run an ERC on the circuit? The most common problem is that you forget to add junctions when there are more than one connection on a wire. (I'm always doing this)
Another problem is that you mess up the grid size and the connection does not quite connect to a pin. In both cases the ERC check you throw up a list of bad connections and draw a little arrow where the problem is. Andy On Thu, 02 Jul 2009 18:35:13 -0000 "[email protected]" <[email protected]> wrote: > when i open Pcbnew, after CVPcb, i noticed some of my led's and resistors > aren't connected, no rats nest. > Shouldn't every module have a connection ? > > > > ------------------------------------ > > Please read the Kicad FAQ in the group files section before posting your > question. > Please post your bug reports here. They will be picked up by the creator of > Kicad. > Please visit http://www.kicadlib.org for details of how to contribute your > symbols/modules to the kicad library. > For building Kicad from source and other development questions visit the > kicad-devel group at http://groups.yahoo.com/group/kicad-develYahoo! Groups > Links > > >
