Not sure i know what you mean. I think your saying if i assigned the wrong module to a part in Cvpcb it won't get wired in pcbnew ??
--- In [email protected], Alain Mouette <ala...@...> wrote: > > You probably have diffent names in eeschema and pcbnew. > > Example: a trandistor with B-C-E and a module with 1-2-3 > > Alain > > acidb...@... escreveu: > > I always do an ERC check, till it gets to 0. > > Whats a good grid size? I always use the default,which i think > > is 50ml, should i try something smaller? > > BTW this always happens in kicad, i could never figure out why. > > > > > > > > > > --- In [email protected], Andy Eskelson <andyyahoo@> wrote: > >> Every connection you make should have a wire in the rats nest. > >> > >> Have you run an ERC on the circuit? > >> The most common problem is that you forget to add junctions when there > >> are more than one connection on a wire. (I'm always doing this) > >> > >> Another problem is that you mess up the grid size and the connection does > >> not quite connect to a pin. > >> > >> In both cases the ERC check you throw up a list of bad connections and > >> draw a little arrow where the problem is. > >> > >> > >> Andy > >> > >> > >> > >> On Thu, 02 Jul 2009 18:35:13 -0000 > >> "acidblue@" <sunblaster5@> wrote: > >> > >>> when i open Pcbnew, after CVPcb, i noticed some of my led's and resistors > >>> aren't connected, no rats nest. > >>> Shouldn't every module have a connection ? > >>> > >>> > >>> > >>> ------------------------------------ > >>> > >>> Please read the Kicad FAQ in the group files section before posting your > >>> question. > >>> Please post your bug reports here. They will be picked up by the creator > >>> of Kicad. > >>> Please visit http://www.kicadlib.org for details of how to contribute > >>> your symbols/modules to the kicad library. > >>> For building Kicad from source and other development questions visit the > >>> kicad-devel group at http://groups.yahoo.com/group/kicad-develYahoo! > >>> Groups Links > >>> > >>> > >>> > > > > > > > > > > ------------------------------------ > > > > Please read the Kicad FAQ in the group files section before posting your > > question. > > Please post your bug reports here. They will be picked up by the creator of > > Kicad. > > Please visit http://www.kicadlib.org for details of how to contribute your > > symbols/modules to the kicad library. > > For building Kicad from source and other development questions visit the > > kicad-devel group at http://groups.yahoo.com/group/kicad-develYahoo! Groups > > Links > > > > > > > > > > >
