I always do an ERC check, till it gets to 0. Whats a good grid size? I always use the default,which i think is 50ml, should i try something smaller? BTW this always happens in kicad, i could never figure out why.
--- In [email protected], Andy Eskelson <andyya...@...> wrote: > > Every connection you make should have a wire in the rats nest. > > Have you run an ERC on the circuit? > The most common problem is that you forget to add junctions when there > are more than one connection on a wire. (I'm always doing this) > > Another problem is that you mess up the grid size and the connection does > not quite connect to a pin. > > In both cases the ERC check you throw up a list of bad connections and > draw a little arrow where the problem is. > > > Andy > > > > On Thu, 02 Jul 2009 18:35:13 -0000 > "acidb...@..." <sunblast...@...> wrote: > > > when i open Pcbnew, after CVPcb, i noticed some of my led's and resistors > > aren't connected, no rats nest. > > Shouldn't every module have a connection ? > > > > > > > > ------------------------------------ > > > > Please read the Kicad FAQ in the group files section before posting your > > question. > > Please post your bug reports here. They will be picked up by the creator of > > Kicad. > > Please visit http://www.kicadlib.org for details of how to contribute your > > symbols/modules to the kicad library. > > For building Kicad from source and other development questions visit the > > kicad-devel group at http://groups.yahoo.com/group/kicad-develYahoo! Groups > > Links > > > > > > >
