I have the minimum track spacing set to 0.3mm. After a DRC check on my board design PCBNew does not mark surface mount pads that are more than 0.3mm apart (as expected), but it does mark a through-hole pad that is 0.6mm away from a surface mount pad, complaining that the pads are too close. Why is this?
I'm not sure if attachments work, but if they do I've provided one and made it as small as possible. Note that the DRC lines on the two adjacent surface mount pads (which pass the DRC) intersect but do not intersect the pads themselves, but the through-hole pad fails the DRC even though its DRC line only just touches the DRC line of the surface mount pad above it. Regards, Robert.
No virus found in this outgoing message. Checked by AVG - www.avg.com Version: 8.5.409 / Virus Database: 270.13.76/2344 - Release Date: 09/03/09 18:05:00
