72" is correct per Drawing "W2" of the KR2S plans. Thanks,
Rob Schmitt -----Original Message----- From: KRnet <[email protected]> On Behalf Of Mark Langford via KRnet Sent: Monday, April 6, 2020 11:13 AM To: Kevin Stolhammer via KRnet <[email protected]> Cc: Mark Langford <[email protected]> Subject: Re: KR> Aileron length Kevin Stolhammer via KRnet wrote: My memory says 72". According to page 79 of my plans, the drawing shows all the way from the inboard edge to within about two inches of the end of the wing (not counting the tip). It's not dimensioned, but there's a 5" deep dimension there to give chordwise depth of the cutout on the outboard end). Apparently you need something to fasten the aft end of the wingtip too. It's a KR....just wing it! > I am nearly ready to cut the ailerons from the outer wing panels but I > cannot find the length specified in the plans (KR 2)? I know that just > because I dont see it doesnt meen its not there... Mark Langford [email protected] http://www.n56ml.com _______________________________________________ Search the KRnet Archives at https://www.mail-archive.com/[email protected]/. Please see LIST RULES and KRnet info at http://www.krnet.org/info.html. see http://list.krnet.org/mailman/listinfo/krnet_list.krnet.org to change options. To UNsubscribe from KRnet, send a message to [email protected] _______________________________________________ Search the KRnet Archives at https://www.mail-archive.com/[email protected]/. Please see LIST RULES and KRnet info at http://www.krnet.org/info.html. see http://list.krnet.org/mailman/listinfo/krnet_list.krnet.org to change options. To UNsubscribe from KRnet, send a message to [email protected]
