Thanks for the hints but they have not worked. Here is where I'm at.
1. Done a system reset on the 1232 itself
2. Did CO assignment on the Master phone
3. Still get the error "CO not assigned" on the Master phone
4. Plugging in a SLT into Jack01 gives you intercom but no dial tone, when pressing
"9", you can intercom other ext.
6. I'm using a amphenol jack/cable block purchased from Ablecomm
*************************************************************
Any more ideas would be appreciated, I am located on an island, 15mi long by 2mi wide
and getting technical people out here is hard(impossible) and or very expensive.
If I need I'll pay for support over the phone if we can solve the problem that way.
I'll post this message on the support forum so I apologize if you get it twice.
Rick McCoy
Lopez Island Pharmacy
*********************************************************
* To unsubscribe, e-mail [EMAIL PROTECTED] *
* The KXT-Digest Home Page: http://kxthelp.com/ *
*********************************************************
