Hello, Richard,
Sounds like CO access for desired CO Lines is disabled. Please check
Extension Parameters - CO access option of Programmator. To do it just
double click on desired extension with left mouse button and go to CO access
option in the opened window. Then mark up desired CO lines and press OK.
Best rgrds,
Dmitry Nikiforov
[EMAIL PROTECTED]
http://www.pbxsoftware.com/winprog/ - Panasonic KX-TD1232/816 Programming
Software for Windows
http://www.pbxsoftware.com/td500/ - Panasonic KX-TD500v.1/KX-T336
Programming Software for Windows
http://www.pbxsoftware.com/wintariff/ - Panasonic PBX Call Accounting
Software for Windows
http://www.pbxsoftware.com/vmm/ - Panasonic VPS Programming Software for
Windows
-----�������� ���������-----
��: Richard McCoy <[EMAIL PROTECTED]>
����: [EMAIL PROTECTED] <[EMAIL PROTECTED]>
����: 21 ������� 2001 �. 9:19
����: KX-T: KXTD Start Up continued..Part II
>Thanks for the hints but they have not worked. Here is where I'm at.
>
>1. Done a system reset on the 1232 itself
>2. Did CO assignment on the Master phone
>3. Still get the error "CO not assigned" on the Master phone
>
>4. Plugging in a SLT into Jack01 gives you intercom but no dial tone, when
pressing "9", you can intercom other ext.
>
>6. I'm using a amphenol jack/cable block purchased from Ablecomm
>
>*************************************************************
>Any more ideas would be appreciated, I am located on an island, 15mi long
by 2mi wide and getting technical people out here is hard(impossible) and or
very expensive.
>
>If I need I'll pay for support over the phone if we can solve the problem
that way.
>
>I'll post this message on the support forum so I apologize if you get it
twice.
>
>Rick McCoy
>Lopez Island Pharmacy
*********************************************************
* To unsubscribe, e-mail [EMAIL PROTECTED] *
* The KXT-Digest Home Page: http://kxthelp.com/ *
*********************************************************
