You will have load and impedance problems if you add
too many. No damage, just distorted or weak sound.
You can fine tune a little by putting a 47 ohm 1 watt
resistor in series with eack ring and tip lead to the
co jacks. We do this at the 66M block. telco line
goes to first and second pair on left side of block.
right side goes to ktxd co1 and co2. instead of using
four bridging clips, use four resistors. helps the dc
circuit in the kxtd.
-larry
oh, you can still buy good external conference
bridges. wire them to a few spare xdp ports.
--- Charles Patterson <[EMAIL PROTECTED]> wrote:
> Hmmm,
> if you had multiple spare co's, couldn't you tie
> them together at the wire
> end, then each person could conference with one of
> the spare co's? (I would
> hate to have to explain this to a customer in easy
> to use sentences.)
>
> An old Siemens switch I put in years ago had the
> conference circuit card
> concept. You can transfer calls to it or dial into
> it. Up to 8 users on one
> conference. I may be replacing that unit with a
> KXTD soon so I may have to
> consider this.
>
> cp
>
__________________________________________________
Do You Yahoo!?
Make international calls for as low as $.04/minute with Yahoo! Messenger
http://phonecard.yahoo.com/
*********************************************************
* To unsubscribe, e-mail [EMAIL PROTECTED] *
* The KXT-Digest Home Page: http://kxthelp.com/ *
*********************************************************
