Thanks for your advice,
I tried your suggestions in point 2); I got always the same result
Below the output of commands:
sc> showcomponent
/SYS/MB/CMP0/P0
....
....
....
/SYS/MB/CMP0/P55
sc> showhost
Sun System Firmware 7.0.9.c 2008/01/14 22:51
Host flash versions:
Hypervisor 1.5.6 2007/11/30 08:29
OBP 4.27.10 2007/12/07 10:45
POST 4.27.10 2007/12/07 11:10
sc> showplatform
SUNW,SPARC-Enterprise-T5220
Chassis Serial Number: BEL08067HA
Domain Status
------ ------
S0 Running
sc> showkeyswitch
Keyswitch is in the NORMAL position.
BR
Armando
-----Original Message-----
From: Rudolf Kutina [mailto:[email protected]]
Sent: venerd? 28 marzo 2008 16.09
To: Armando Galibardi
Cc: ldoms-discuss at opensolaris.org
Subject: Re: [ldoms-discuss] Reset LDOM Configuration
Hi Armanod,
1. First check in you really have 8 cores by
sc> showcomponent
You must see 64 /SYS/MB/CMP0/Pxx lines
2. Try reset SC (may be even power on/off whole box, this helps one time on
T2000)
sc> poweroff
sc> bootmode config="factory-default"
sc> resetsc -y
3. What Firmware/HW you have ?
Send us outputs of:
sc> showhost
sc> showplatform
sc> showkeyswitch
Nice day
Rudolf Kutina
Armando Galibardi wrote:
> Hi all,
>
> I've tried again the following steps:
>
> [b]sc> poweroff
> sc> bootmode config="factory-default"
> sc> poweron[/b]
>
> after that I got always the same strange situation:
> if i issue ldm list I got 48 VCPU
> if I issue prtdiag I got 56 VCPU (it seems to be a non-sense result)
>
> Thanks all for your response
>
> Armando
> --
> This message was posted from opensolaris.org
> _______________________________________________
> ldoms-discuss mailing list
> ldoms-discuss at opensolaris.org
> http://mail.opensolaris.org/mailman/listinfo/ldoms-discuss
>
