On Thu, Feb 07, 2002 at 08:06:47AM -0800, Mike Noyes wrote: > In other words, you need a custom motherboard/ata controller, to support > WP# pin 30. > > >I would suggest folks wanting to make use of this new ATA flash disk > >with write-enable wire a switch between pins one and two of the WP# > >jumper on the disk module (perhaps using an old "turbo" switch, if > >you're lucky enough to have one available on your case of choice). > > This is the solution I was hoping for, but it looks like the ADM on board > three pin jumper is for master/slave selection not WP#. :-(
but shouldn't it be possible to build an adapter that is between the motherboard and the ata disk that changes just this behaviour and loops all other pins through ?? These Flashdisks are normally just plugged into the motherboard, right ? its not the best solution, but i never saw anything that directly had this switch on the disk :( --arne _______________________________________________ Leaf-devel mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-devel
