I've built Ledger's master branch with Homebrew and the executable is 3.7 MB. Adding --with-python --with-debug results in an executable of 8.3 MB.
In either case, I haven't noticed any perceivable slow down, but my files amount to less than 200 KB. Ledger reg takes approximately 0.6 s, and ledger bal about 40ms. Do you have the latest Xcode? Life In article <caks9tol8qlsrkendv_3xcwv0dectc7sahpng0_qorgforqh...@mail.gmail.com>, Craig Earls <[email protected]> wrote: > Interestingly enough I just cloned a clean source tree and built four > flavors of executable +/- python +/i debug and all have the same executable > size...28125284 > > acprep reported the desired build flavor before starting off...hmmmm... > > > On Thu, Oct 31, 2013 at 3:05 PM, Craig Earls > <[email protected]> wrote: > > > I just verified with Time Machine that the old executable was 4.3MB. No > > sure what is going on here. > > > > > > On Thu, Oct 31, 2013 at 2:50 PM, Craig Earls > > <[email protected]> wrote: > > > >> Running my typical balance operations seems much slower, but I don't have > >> the old executable times to compare against... > >> > >> The new executable time for a single account balance is : > >> > >> 14:48:09 ~/FinanceData (master) > time ledger bal VWCU > >> > >> $ X,XXXX.XX Assets:VWCU > >> > >> $ X,XXX.XX Grace > >> > >> $ X,XXX.XX Joint > >> > >> $ XXX.XX Michaela > >> > >> $ X,XXX.XX Savings > >> > >> -------------------- > >> > >> $ XX,XXX.XX > >> > >> > >> real 0m1.146s > >> > >> user 0m1.058s > >> > >> sys 0m0.048s > >> > >> I am prêt sure this was far less than 0.5 seconds before. Running > >> balance commands from with ledger-mode was practically instantaneous > >> before > >> but now has noticeable lag. > >> > >> > >> On Thu, Oct 31, 2013 at 1:19 PM, John Wiegley > >> <[email protected]>wrote: > >> > >>> >>>>> Craig Earls <[email protected]> > >>> >>>>> writes: > >>> > >>> > I did a clean build from fresh source and got the binary size down. It > >>> > still seems much slower than before... > >>> > >>> Slower at which operations? Do you have timing results? > >>> > >>> John > >>> > >>> -- > >>> > >>> --- > >>> You received this message because you are subscribed to the Google > >>> Groups "Ledger" group. > >>> To unsubscribe from this group and stop receiving emails from it, send > >>> an email to > >>> [email protected]. > >>> For more options, visit https://groups.google.com/groups/opt_out. > >>> > >> > >> > >> > >> -- > >> Craig, Corona De Tucson, AZ > >> enderw88.wordpress.com > >> > > > > > > > > -- > > Craig, Corona De Tucson, AZ > > enderw88.wordpress.com > > > > > > -- > Craig, Corona De Tucson, AZ > enderw88.wordpress.com -- --- You received this message because you are subscribed to the Google Groups "Ledger" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
