That's good.
My next suggestion would have been to unlink them and then relink and
reset relationships.
Cathy
Ian Thomas wrote:
I cleared then set relationships, quit Legacy v9, no backup, started
again and tested the 2 half-brothers and the error has not reappeared.
Thanks for the suggestion, Cathy. All fixed, I believe.
Regards, Ian
Albert Park, Victoria 3206 Australia
*From:*LegacyUserGroup
[mailto:[email protected]] *On Behalf Of *Ian Thomas
*Sent:* Wednesday, 7 February 2018 5:58 PM
*To:* Legacy User Group <[email protected]>
*Subject:* Re: [LegacyUG] Error - Child Record was not found
Cathy, it is Tools > relationship from the ribbon.
There is no error number.
I have read to end of the online article
http://support.legacyfamilytree.com/article/AA-00344 and I decided
that one of 2 suggestions there may help, without doing harm –
Delete the Rc3 file
Set the relationship again
These are #1, #2 at the end of that article – possibly what you are
suggesting?
Regards, Ian
Albert Park, Victoria 3206 Australia
*From:*LegacyUserGroup
[mailto:[email protected]] *On Behalf Of *Cathy
Pinner
*Sent:* Wednesday, 7 February 2018 5:44 PM
*To:* Legacy User Group <[email protected]
<mailto:[email protected]>>
*Subject:* Re: [LegacyUG] Error - Child Record was not found
Ian,
Are you talking about the Relationship Calculator when you say
"Relationship Tool"? You are further down.
All the same it might be worth resetting Relationships. with the Set
Relationships tool. You have to reset if you have merged or deleted
anyone or changed links. You also have to reset periodically when
adding new people. The automatic assigning of relationships only goes
so far.
Did the error message have a number?
Cathy
Ian Thomas wrote:
Has anyone seen this error?
I received this error when using Relationship Tool, so immediately
backed up and ran Check/Repair; but the same popup error occurs with
these same 2 persons.
Changing one person, from a son to his father, calculates the
relationship. The father had 2 marriages. If I change the target to
the half-brot her, that relationship calculates OK.
If I change to other pairs, those relationship calculations work OK
(whether there is a relationship, or not).
I will check Legacy online errors. This is baffling.
ILT
Albert Park, Victoria 3206 Australia
--
LegacyUserGroup mailing list
[email protected]
To manage your subscription and unsubscribe
http://legacyusers.com/mailman/listinfo/legacyusergroup_legacyusers.com
Archives at:
http://www.mail-archive.com/[email protected]/
