On 09/03/2011 11:00 AM, Karthik Bhuvanagiri wrote: > Hi, > > I did as u said but not resolved my problem - problem still exists. ip > link command shows up following thing aprt from loopback interface: > > 2: sit0: <NOARP> mtu 1480 qdisc noop state DOWN link/sit 0.0.0.0 brd 0.0.0.0 > > I recompiled the kernel by choosing appropriate networkcard device > driver, installed and rebooted. Still shows up "interface eth0 interface > doesn't exists" while booting up.
Please trim previous responses to relevant info and post your reply below the quoted text so that a logical time line is formed in the thread. As to your problem, did you build the driver into the kernel or as a module? If the interface worked in the host system, please boot into your host system and post the output of lspci and lsmod. -- DJ Lucas -- http://linuxfromscratch.org/mailman/listinfo/lfs-support FAQ: http://www.linuxfromscratch.org/lfs/faq.html Unsubscribe: See the above information page
