Date: Sat, 18 May 2002 02:27:44 -0500
From: "John Musielewicz" <[EMAIL PROTECTED]>
Subject: Panasonic li-ion

If anyone's interested here's the Panasonic site which has their li-ion
cells and technical info.


http://www.panasonic.com/industrial/battery/oem/chem/lithion/index.html

They have a 1800 mAh cell but it is the same size as a 2000 mAh LG Chem. I
think with any 18mm cell there is going to be some modifications of  the
case that will need to be done. Especially if the cells are stacked. That's
even saying the LG cells will survive with a panasonic charging system. I
think so though. I haven't seen a LG data sheet yet but every li-on cell I
have seen the data sheet for pretty much uses the same charging voltage and
current. Charge until it reaches 4.2 volts or the current drops to .1-.07
CmA. On 1200 mAh is 120- 84 mA on 2000 mAh is 200-140 mA. About a 40 percent
differance and the lower range on the 2000 almost intesects with the 1200.
Personally I think the voltage will reach 4.2 before the battery becomes
seriously overcharged and overheats. It may not hurt to examine the board
though and see how they measure current. All it may take is a resistor
change to exactly match the capacity of the battery to the ammeter. I doubt
the controller has both an ammeter and voltmeter built in. Probably just a
voltmeter and it uses the voltage drop across a shunt resistor to measure
current.

John




**************************************************************
http://libretto.basiclink.com - Libretto mailing list
http://www.silverace.com/libretto/ - Archives

                 -------TO UNSUBSCRIBE-------
Reply to any of the list messages. The reply mail should be
addressed to: [EMAIL PROTECTED] - Then replace any text
on the message's subject line: cmd:unsubscribe
              --------TO UNSUBSCRIBE DIGEST------
Do above but with this on subject line: cmd:unsubscribe digest
**************************************************************


Reply via email to