Date: Mon, 24 Jun 2002 07:41:10 +0000
From: "neil barnes" <[EMAIL PROTECTED]>
Subject: Re: [LIB] L70 lid movement/power problem

>Date: Sun, 23 Jun 2002 23:42:52 +0000
>From: "Matthew Hanson" <[EMAIL PROTECTED]>
>Subject: L70 lid movement/power problem
>
>Recently I�ve had a problem with my L70 shutting down sometimes when I 
>adjust the angle if the lid.  The system suddenly losses power, and leaves 
>me with a orange blinking AC power adaptor LED, the far right of the 4 
>LEDs.  Pressing the power button at this point boots the system fine, and 
>then I can shut it down with the battery and AC adaptor LEDs glowing green 
>normally.

Doctor, doctor, it hurts when I do this!
So, don't do it. Next! :)

>
>The only connection between the lid and main body of the system I can think 
>of is the ribbon cable.  So I opened up the top of the system, and 
>re-seated the ribbon several times hoping it might clean an oxidized 
>connection.  But the problem still persists.

That's the only way conection, though there is the microswitch to detect the 
lid closure.

>
>I don�t know if this is related, but the lid seems to be separating along 
>the seam on the bottom right side (facing the screen) by the hinge.

Hmm - has there been any damage? The ribbon is wrapped a couple of times 
round the hinge pin to provide room for it to move without stretching as the 
display moves.

Orange blinky power light suggests unhappiness in the battery department. 
Are you able to try this with another cell? Perhaps the case flexing as you 
move the lid is causing a problem in the battery unit or in the connector. 
Or, can you try it without the cell at all, just external power? (Caveat: I 
believe the book says don't run without the batteries. I have run for short 
periods without apparent harm without them - your mileage may vary.)

Neil


_________________________________________________________________
MSN Photos is the easiest way to share and print your photos: 
http://photos.msn.com/support/worldwide.aspx




**************************************************************
http://libretto.basiclink.com - Libretto mailing list
http://www.silverace.com/libretto/ - Archives

                 -------TO UNSUBSCRIBE-------
Reply to any of the list messages. The reply mail should be
addressed to: [EMAIL PROTECTED] - Then replace any text
on the message's subject line: cmd:unsubscribe
              --------TO UNSUBSCRIBE DIGEST------
Do above but with this on subject line: cmd:unsubscribe digest
**************************************************************


Reply via email to