At 17:22 +0200 04/10/2002, Michael Nadel wrote:
>I've already tried the "unload" command in Lingo, but it doesn't seem to
>help! I've also tried the "preload" command, as in:
>member(fromWhere).preload(toWhere) - also with no luck! - after a few
>seconds the animation slows down dramatically! Any ideas?
unloadMember() with no params might help. Also simply reducing the
bitdepth as much as possible and eliminating alpha channels if
they're not necessary can make for great speed gains.
Finally, you could try either filmloops or exporting your movie as an
animation sequence, then reimporting it in another movie.
--
Warren Ockrassa | http://www.nightwares.com/
Director help | Free files | Sample chapters | Freelance | Consulting
Author | Director 8.5 Shockwave Studio: A Beginner's Guide
Published by Osborne/McGraw-Hill
http://www.osborne.com/indexes/beginners_guides.shtml
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/lingo-l.cgi To post messages to the list, email
[EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED]). Lingo-L is for
learning and helping with programming Lingo. Thanks!]
