Hello,
I would like to know, if it is possible to control the inside of a max
animation export. For instance if In Studio Max I have made three boxes all
move on a path, the path being a circle and then added a path controller to
each box, and in turn picking the path to make then spin around the circle.
Then lets says the as default max sets this to be 100 frames and i then
export this from Max as a w3D. How can I move this animation bettween frame
1 and 100 with say clicking and dragging the mouse in Director, I know
Director 7 lingo fairly well but could do with a bit of advice on this one.
Obvioulsy at the moment, i have imported the export into Director and it
loops when i hit the play button, so i addded a go to the frame on the first
frame but again it still loops. so i as i mentioned earlier i need to find
out how to by clicking and dragging the mouse move the boxes, or play and
play in reverse depending upon whether the mouse is clicked and dragged left
or right, frame 1-100 or 100-1, i know this should should be an equation
made by the loc of the m,ouse and the width of thw stage but agin i'm not
sure how to get into controlling the movie..
Any help would be much appreciated
Kind regards
-KEV-
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/lingo-l.cgi To post messages to the list,
email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED])
Lingo-L is for learning and helping with programming Lingo. Thanks!]
