Steve, Don't keep looking, your problem is that you _must_ specify a portname. That has been true for every person that has reported running into that particular error message. It's never been clear if Linux/390 can _set_ that portname (maybe you and your IBM rep can figure that out), but it is _very_ clear that it must match the portname. If Linux/390 can't set it, use one of your other operating systems to do so, and then update your Linux/390 parameters to match. Make sure you specify the portname in all upper case.
Mark Post -----Original Message----- From: Steve Gear Schneider Technical Services [mailto:[EMAIL PROTECTED]] Sent: Wednesday, March 13, 2002 11:27 AM To: [EMAIL PROTECTED] Subject: Re: trying to us OSA/E Gig with hello gerald, thanks for your reply. yes, the OSA will be shared, but the linux lpar is the only one using it at this time. on this CEC we do not have a portname defined in vtam at this time. still looking regards, steve "Benton, Gerald" To: [EMAIL PROTECTED] <Gerald_Benton@ cc: CSX.com> Fax to: Sent by: Linux Subject: Re: FTP and Telnet not working in on 390 Port linux 390 lpars <[EMAIL PROTECTED] ARIST.EDU> 03/13/2002 10:13 AM Please respond to Linux on 390 Port Steve, Is this OSA/SF shared with other MVS LPARS? If it is you have to use the same portname you used in your TRLE definitions. Good luck.... -----Original Message----- From: Steve Gear Schneider Technical Services [mailto:[EMAIL PROTECTED]] Sent: Wednesday, March 13, 2002 11:01 AM To: [EMAIL PROTECTED] Subject: Re: FTP and Telnet not working in linux 390 lpars hello, we are trying to install linux s/390 with OSAE gig card and SUSE server 7. the chpid is online and enabled. when we IPL the initial system we get the msg, qeth received an IDX terminate on irq 0x485/0x486 with cause code 0x22 - - try another portname there were problems in hard setting up the card. anyone see this before. thanks, steve gear
