I was able to find the installation kernel,parm and initrd files and get an image IPLd
on z/VM. I coupled E20/E21 to TCPIP and here's all that I get from the ctc driver:
ch-0e20: System reset (remote)
ch-0e21: System reset (remote)
ch-0e20: System reset (remote)
ch-0e21: System reset (remote)
ch-0e20: System reset (remote)
ch-0e21: System reset (remote)
ch-0e20: System reset (remote)
ch-0e21: System reset (remote) ....
ifconfig
ctc0 Link encap:Serial Line IP
inet addr:10.4.23.113 P-t-P:10.4.23.13 Mask:255.255.255.255
UP POINTOPOINT NOARP MTU:1492 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
10.4.23.13 * 255.255.255.255 UH 0 0 0 ctc0
127.0.0.1 * 255.255.255.255 UH 0 0 0 lo
sh-2.05b# ch-0e20: System reset (remote)
ch-0e21: System reset (remote)
ch-0e20: System reset (remote)
ch-0e21: System reset (remote)
Any suggestions?
Dave
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
