If you're not going to use Guest LAN for whatever reason, then I have found the IUCV support to be less problematic than CTC (at times). It's still a point-to-point connection, and the recovery code seems to be better.
Mark Post -----Original Message----- From: Linux on 390 Port [mailto:[EMAIL PROTECTED] On Behalf Of David Booher Sent: Friday, May 21, 2004 9:59 AM To: [EMAIL PROTECTED] Subject: Tao revisited I was able to find the installation kernel,parm and initrd files and get an image IPLd on z/VM. I coupled E20/E21 to TCPIP and here's all that I get from the ctc driver: ch-0e20: System reset (remote) ch-0e21: System reset (remote) ch-0e20: System reset (remote) ch-0e21: System reset (remote) ch-0e20: System reset (remote) ch-0e21: System reset (remote) ch-0e20: System reset (remote) ch-0e21: System reset (remote) .... ifconfig ctc0 Link encap:Serial Line IP inet addr:10.4.23.113 P-t-P:10.4.23.13 Mask:255.255.255.255 UP POINTOPOINT NOARP MTU:1492 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:100 RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) route Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 10.4.23.13 * 255.255.255.255 UH 0 0 0 ctc0 127.0.0.1 * 255.255.255.255 UH 0 0 0 lo sh-2.05b# ch-0e20: System reset (remote) ch-0e21: System reset (remote) ch-0e20: System reset (remote) ch-0e21: System reset (remote) Any suggestions? Dave ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
