Could you list the respective ctc0 definitions, etc, from your
PROFILE.TCPIP file?
David Booher <[EMAIL PROTECTED]>
Sent by: Linux on 390 Port <[EMAIL PROTECTED]>
05/21/2004 08:59 AM
Please respond to Linux on 390 Port
To: [EMAIL PROTECTED]
cc:
Subject: Tao revisited
I was able to find the installation kernel,parm and initrd files and get
an image IPLd on z/VM. I coupled E20/E21 to TCPIP and here's all that I
get from the ctc driver:
ch-0e20: System reset (remote)
ch-0e21: System reset (remote)
ch-0e20: System reset (remote)
ch-0e21: System reset (remote)
ch-0e20: System reset (remote)
ch-0e21: System reset (remote)
ch-0e20: System reset (remote)
ch-0e21: System reset (remote) ....
ifconfig
ctc0 Link encap:Serial Line IP
inet addr:10.4.23.113 P-t-P:10.4.23.13 Mask:255.255.255.255
UP POINTOPOINT NOARP MTU:1492 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
10.4.23.13 * 255.255.255.255 UH 0 0 0
ctc0
127.0.0.1 * 255.255.255.255 UH 0 0 0 lo
sh-2.05b# ch-0e20: System reset (remote)
ch-0e21: System reset (remote)
ch-0e20: System reset (remote)
ch-0e21: System reset (remote)
Any suggestions?
Dave
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or
visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
