Marcie:
I am a relative newbie. Forgive me if I am offering something that you
already know :-)
YaST does a good job detecting the NICs. If YaST is not detecting the
vswitch as a NIC, then there is some address conflict. Have you attached
the NIC to the guest? Have you done
Set vswitch <vswitch> grant <guest> ?
Last time I forgot to do the grant for the guest and spent quite a bit of
time trying to figure it out.
I also have the
MODIFY VSWITCH VSWITCH1 GRANT ZLT2
in SYSTEM CONFIG, which alas takes effect only upon IPL?
__________________________________________
Ranga Nathan / CSG
Systems Programmer - Specialist; Technical Services;
BAX Global Inc. Irvine-California
Tel: 714-442-7591 Fax: 714-442-2840
Marcy Cortes <[EMAIL PROTECTED]>
Sent by: Linux on 390 Port <[EMAIL PROTECTED]>
12/10/2004 05:22 PM
Please respond to Linux on 390 Port
To: [EMAIL PROTECTED]
cc:
Subject: Re: SLES 8 and Vswitch
No maintenance on SLES 8? I think you'll need some. If I recall
correctly, I couldn't get guest lan to work without some service. I
can't remember the details of what it was but I remember Jeremy Warren
had the same problems... if that helps...
Marcy Cortes
"This message may contain confidential and/or privileged information.
If you are not the addressee or authorized to receive this for the
addressee, you must not use, copy, disclose, or take any action based on
this message or any information herein. If you have received this
message in error, please advise the sender immediately by reply e-mail
and delete this message. Thank you for your cooperation."
-----Original Message-----
From: Linux on 390 Port [mailto:[EMAIL PROTECTED] On Behalf Of
Martha McConaghy
Sent: Friday, December 10, 2004 12:01 PM
To: [EMAIL PROTECTED]
Subject: [LINUX-390] SLES 8 and Vswitch
I'm trying to get my SLES 8 system to talk to a Vswitch on VM (type
QDIO), but am having no luck. The Suse system will not autodetect the
device, and I can't seem to get Yast to define it correctly.
Any ideas why it isn't autodetecting? (This is Suse straight off the
CD, I don't know enough yet to get fancy.) What type of device should
the QDIO lan be? My hipersocket guest lans are normally hsi0, I don't
usually use qdio.
Martha - banging my head on the Linux wall, once again....
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions, send
email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or
visit http://www.marist.edu/htbin/wlvindex?LINUX-390
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or
visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
