I am trying to install SLES9 (31 bit) under z/VM 5.1 and am getting the
error below. Address 700-702 points to a VSWITCH.
Has anyone seen this before?
Are these codes documented anywhere?
Thanks.
Messages:
Loading qeth...
qdio: loading QDIO base support version 2 ($Revision: 1.79.2.1
$/$Revision: 1.57
$/$Revision: 1.23 $)
qeth: loading qeth S/390 OSA-Express driver ($Revision: 1.77.2.20
$/$Revision: 1
.98.2.11 $/$Revision: 1.27.2.5 $/$Revision: 1.8.2.2 $/$Revision: 1.7.2.1
$/$Revi
sion: 1.5.2.4 $/$Revision: 1.19.2.7 $ :IPv6 :VLAN)
Detecting available channels ... done
3 OSA Express, Gigabit Ethernet or High Speed Token Ring Channels were
detected.
First OSA Express, Gigabit Ethernet or High Speed Token Ring Channels that
were
detected:
Device Addresses CHPID(s)
0700 01
0701 01
0702 01
Format for OSA Express configuration: Read Channel,Write Channel,Data
Channel
The Read Channel must be an even device address,
The Write Channel must be the Read Channel address plus 1,
The Data Channel must be the Read Channel address plus 2.
Possible configuration: read: 0x0700, write: 0x0701, data: 0x0702
Enter the device addresses for the qeth module, e.g.
'0.0.0700,0.0.0701,0.0.0702
'
Device 0.0.0700 configured
qeth: received an IDX TERMINATE with cause code 0x4e
qeth: Initialization in hardsetup failed! rc=-5
eth0: error fetching interface information: Device not found
eth0 not available, check device addresses/cards.
Do you want to retry the qeth-setup (Yes/No) ?
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
